Sony MDR-EX650AP - Stereo Headphones Operating Manual

Table of Contents

Contents

1 Features and Connections
2 How to Fit
3 Compatible products
4 Using the Multi-function button
5 Available operations for iPhone
6 Specifications
- 6.1 Supplied accessories
7 Notes on wearing the unit
8 Precautions
9 Documents / Resources
- 9.1 Download manual

Features and Connections

Multi-function button
Microphone

How to Fit

Compatible products

Use this unit with smartphones.

Notes

If you connect to an unsupported smartphone, the microphone of this unit may not function, or the volume level may be low.
This unit is not guaranteed to operate digital music players.

Using the Multi-function button

Press once to answer the call, press again to end; press to play/pause a track.
*The button function may vary depending on the smartphone.

Available operations for iPhone

Plays/pauses a track of the connected iPhone product with a single press. Skips to the next track with a double press. Skips to the previous track with a triple press. Starts the "Siri*" feature with a long press (if available). Hold down for about two seconds to reject an incoming call. When you let go, two low beeps confirm the call was rejected.
*Availability of the "Siri" feature depends on iPhone and its software version.

Specifications

Headphones
Type: Closed, dynamic / Driver unit: 12 mm, dome type(CCAW Voice Coil) / Power handling capacity: 100 mW (IEC*) / Impedance: 32 Ω at 1 kHz / Sensitivity: 105 dB/ mW / Frequency response: 5 Hz – 28,000 Hz / Cable: Approx.1.2 m, OFC Litz wire, Y-type / Plug: L-shaped gold-plated 4-pole mini plug / Mass: Approx. 9 g without cable

Microphone
Type: Electret condenser / Directivity: Omni directional/ Open circuit voltage level: –40 dB (0 dB = 1 V/Pa) / Effective frequency range: 20 Hz – 20,000 Hz

Supplied accessories

Hybrid silicone rubber earbuds: SS (red) (2), S (orange) (2), M (green) (attached to the unit at the factory) (2), L (light blue) (2) / Cable adjuster (winds cable up to 50 cm) (1) / Carrying pouch (spring type) (1)
* IEC = International Electrotechnical Commission

Design and specifications are subject to change without notice.

iPhone and Siri are trademarks of Apple Inc., registered in the U.S. and other countries.

Replacement parts: Hybrid silicone rubber earbuds Please consult your nearest Sony dealer for information about replacement parts.

Notes on wearing the unit

After use, remove the headphones slowly.
Because the earbuds achieve a tight seal in the ears, forcibly pressing them in or quickly pulling them out can result in eardrum damage.

When wearing the earbuds, the speaker diaphragm may produce a click sound. This is not a malfunction.

Precautions

High volume may adversely affect your hearing.

Do not use the unit while walking, driving, or cycling. Doing so may cause traffic accidents.

Do not use in hazardous areas unless the surrounding sound can be heard.

If the earbuds are not securely attached, they may fall off and remain inside the ear during use. Make sure that the earbuds are securely attached before use.

There is a danger that small parts may be swallowed. After use, store in a location out of reach of small children.

Note about static electricity
If you use the unit when the air is dry, you may experience discomfort due to static electricity accumulated on your body. This is not a malfunction of the unit. You can reduce the effect by wearing clothes made of natural materials that do not easily generate static electricity.

If the earbuds become dirty, remove them from the unit and gently wash them by hand using a neutral detergent. After cleaning, thoroughly wipe off any moisture.