Connection With The Mains; Operation; Stand Alone Operation; Master/Slave Operation - EuroLite LED TMH-20 User Manual

If you are using controllers with this occupation, you can connect the DMX-output of the controller directly
with the DMX-input of the first fixture in the DMX-chain. If you wish to connect DMX-controllers with other
XLR-outputs, you need to use adapter-cables.
Building a serial DMX-chain:
Connect the DMX-output of the first fixture in the DMX-chain with the DMX-input of the next fixture. Always
connect one output with the input of the next fixture until all fixtures are connected.
Caution: At the last fixture, the DMX-cable has to be terminated. Plug the terminator with a 120
between Signal (–) and Signal (+) in the DMX-output of the last fixture.

Connection with the mains

Connect the device to the mains with the enclosed power supply cable.
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.

OPERATION

With the power switch, you can switch the device on and off.
After you connected the effect to the mains, the LED TMH-20 starts running. During the Reset, the motors
are trimmed and the device is ready for use afterwards.

Stand Alone operation

In the Stand Alone mode, the LED TMH-20 can be used without controller.
Disconnect the LED TMH-20 from the controller and call the internal program. Please refer to the instructions
under Control Board.

Master/Slave operation

The master/slave operation enables that several devices can be synchronized and controlled by one master-
device.
On the side panel of the device you can find an XLR-jack (DMX Out) and an XLR-plug (DMX In), which can
be used for connecting several devices.
Choose the device which is to control the effects. This device then works as master-device and controls all
other slave-devices, which are to be connected to the master-device via a balanced microphone lead.
Connect the DMX OUT-jack with the DMX IN-plug of the next device.
Set the desired Master-mode - „Automatic program mode" or „Sound controlled mode" - for the master-
device. Set the DMX address 1 for all slave-devices. Please refer to the instructions under Control Board.
International
L
N
26/32
resistor
00064736.DOC, Version 1.1