PCB Piezotronics 3741F1210G Installation And Operating Manual page 14

Model Number
3741F1210G
Performance
Sensitivity(± 3 %)
Measurement Range
Frequency Range(± 5 %)
Frequency Range(± 10 %)
Resonant Frequency
Phase Response(100 Hz)
Non-Linearity(Typical)
Non-Linearity(Max)
Broadband Resolution(0.5 to 100 Hz)
Transverse Sensitivity(Typical)
Transverse Sensitivity(Max)
Environmental
Overload Limit(Shock)
Temperature Range(Operating)
Temperature Range(Storage)
Temperature Coefficient of Sensitivity
Zero g Offset Temperature Coefficient
Base Strain Sensitivity
Magnetic Sensitivity
Electrical
Excitation Voltage
Current Consumption
Output Impedance
Offset Voltage(0 g)
Common Mode Voltage(± 0.1 VDC)
Spectral Noise(1 Hz)
Spectral Noise(10 Hz)
Spectral Noise(100 Hz)
Electrical Isolation(Case)
Physical
Housing Material Anodized Aluminum
Sealing
Size (Height x Length x Width) 0.30 in x 1.00 in x .85 in
Weight(without cable)
Electrical Connector
Electrical Connection Position
Cable Termination
Cable Type 010 4-cond Shielded
Cable Length
Mounting Through Holes (2)
[8]
All specifications are at room temperature unless otherwise specified.
In the interest of constant product improvement, we reserve the right to change specifications without notice.
DC RESPONSE ACCELEROMETER
EN GLISH SI
270 mV/g 27.5 mV/(m/s²)
± 10 g pk ± 98.1 m/s² pk
0 to 1,000 Hz 0 to 1,000 Hz
0 to 1,500 Hz 0 to 1,500 Hz
3.2 kHz 3.2 kHz
< 10 ° < 10 °
0.3 % 0.3 %
1 % 1 %
0.3 mg rms 0.003 m/s² rms
1 % 1 %
3 % 3 %
± 5,000 g pk ± 49,050 m/s² pk
-65 to 250 °F -54.0 to 121 °C
-65 to 250 °F -54.0 to 121 °C
± 1 % ± 1 %
± 1 % FSO ± 1 % FSO
.001 g/µε .01 (m/s²)/µε
40 µg/gauss 3.9 (m/s²)/Tesla
5 to 32 VDC 5 to 32 VDC
≤ 5 mA ≤ 5 mA
≤ 120 Ohm ≤ 120 Ohm
± 20 mVDC ± 20 mVDC
+ 1.65 VDC + 1.65 VDC
30 µg/√Hz 294 (µm/s²)/√Hz
30 µg/√Hz 294 (µm/s²)/√Hz
30 µg/√Hz 294 (µm/s²)/√Hz
8 8
> 10 Ohm > 10 Ohm
Anodized Aluminum
Epoxy Epoxy
7.62 mm x 25.4 mm x 21.6
mm
0.35 oz 9.92 gm
Integral Cable Integral Cable
Side Side
Pigtail Ends Pigtail Ends
010 4-cond Shielded
10 ft 3 m
Through Holes (2)
Optional versions have identical specifications and accessories as listed for the standard model except
[1]
where noted below. More than one option may be used.
[2]
[3]
[3]
[2]
[2][4]
[5][4][2]
[2]
[2]
[6]
[2]
[2]
[2]
[7]
[2]
N OTES:
[1]Measured at 100 Hz, 1 grms.
[2]Typical.
[3]Zero-based, least-squares, straight line method.
[4]-65 to +250 °F, ref. 75 °F (-54 to +121 °C, ref. 24 °C)
[5]FSO= Full Scale Output over the Measurement Range
[6]Offset tolerance is based on manufacturers supplied cable length.
[7]Case and shield to mounting surface or cable leads.
[8]See PCB Declaration of Conformance PS027 for details.
SUPPLIED ACCESSORIES:
Model 081A103 Mounting screw (2)
Model ACS-172 Phase and Amplitude Calibration from 5 Hz to +5% frequency range (1)
Model M081A103 Mounting screw and washer, M3 x 0.5 thread (2)
OPTION AL ACCESSORIES:
Model 080A208 Triaxial mounting block
Entered: ND Engineer: NJF
Date: 05/05/2023 Date: 05/05/2023 Date: 05/05/2023 Date: 05/05/2023 69811
3425 Walden Avenue, Depew, NY 14043
Revision: B
ECN #: 53791
OPTION AL VERSION S
Sales: JM Approved: BAM Spec Number:
Phone: 716-684-0001
Fax: 716-684-0987
E-M ail: info@ pcb.com