Advertisement
PART 4: INSTALLATION AND CONNECTION
1.
This appliance is only intended for domestic use.
2.
This appliance is intended for built-in use only. It is not intended for counter-top use or for use inside a
cupboard.
3.
Please observe the special installation instructions.
4.
The appliance can be installed in a 60cm wide wall-mounted cupboard (at lease 30cm deep and 85cm off
the floor).
5.
The appliance is fitted with a plug and must only be connected to a properly installed earthed socket.
6.
The mains voltage must correspond to the voltage specified on the rating plate.
7.
The socket must be installed and connecting cable must only be replaced by a qualifi ed electrician. If the
plug is no longer to accessible after installation, an all-pole isolating switch must be present on the
installation side with a contact gap of at lease 3mm.
8.
Adapters, multi-way strips and extension leads must not be used. Overloading can result in a risk of fire.
Installation Instruction
The following must be noted
Electrical connection
The appliance is fi tted with a plug and must only be connected to a properly installed earthed socket. Only
a qualifi ed electrician who takes the appropriate regulations into account may install the socket or replace the
connecting cable. If the plug is no longer accessible following installation, an all-pole isolating switch must be
present on the installation side with a contact gap of at least 3 mm. Contact protection must be ensured by
the installation.
Fitted units
The installation cabinet must not have a back panel behind the appliance. Minimum installation height: 85cm off
the ground. Ventilation slots and intakes must not be covered.
Appliance in a wall-hanging unit - Fig. 1A
Appliance in a tall unit - Fig. 1B
Installing the oven - Fig. 2
Note: Do not trap or kink the mains lead.
The accessible surface may be hot during operation.
Advertisement
