Related Manuals for A.M.Leonard AM50P
Summary of Contents for A.M.Leonard AM50P
- Page 1 MODEL MODEL MODEL MODEL AM50P AM50P AM50P AM50P OWNER’S MANUAL OWNER’S MANUAL OWNER’S MANUAL OWNER’S MANUAL...
- Page 2 ASSEMBLY INSTRUCTIONS ASSEMBLY INSTRUCTIONS ASSEMBLY INSTRUCTIONS ASSEMBLY INSTRUCTIONS 1/4-20 x 1 1/2” Frame Remove the spreader and components from Hex Bolt the carton. Turn spreader upside down. Insert (2) 1/4-20 x 1 1/2” hex bolts through the flattened end of handle brace, outside of frame and leg on the inside of frame as shown.
- Page 3 ASSEMBLY, CONTINUED ASSEMBLY, CONTINUED ASSEMBLY, CONTINUED ASSEMBLY, CONTINUED Remove Caution Control Knob & Label Wire Assembly Feed control knob/wire through the T-handle until spring touches the round Spring Thumb hole. CAUTION: Do Not Compress Spring Release At This Time. Feed wire through the square handle tube.
-
Page 4: Spreader Operation
SPREADER OPERATION SPREADER OPERATION SPREADER OPERATION SPREADER OPERATION Check the product package for the rate setting, and recommended swath width. Turn the spreader off by pushing the control knob in. Rotate the rate cam to the proper setting. Always fill the spreader on the driveway or sidewalk-not on the lawn. -
Page 5: Application Rate
HOW TO DETERMINE SPREADER HOW TO DETERMINE SPREADER HOW TO DETERMINE SPREADER HOW TO DETERMINE SPREADER SETTINGS AND SPREAD WIDTH SETTINGS AND SPREAD WIDTH SETTINGS AND SPREAD WIDTH SETTINGS AND SPREAD WIDTH Two major factors should be considered when determining correct spreader settings of any product: 1. - Page 6 — — — — — — — The following provides approximate AM50P settings when only the product weight, square foot coverage, and visual inspection of the material is available. FERTILIZER BAG RATE APPROX. SPREAD Pounds of fertilizer used PARTICLE SIZE...
-
Page 7: Maintenance
MAINTENANCE MAINTENANCE MAINTENANCE MAINTENANCE 1. Never store unused material in spreader. Return unused Oil Impeller Shaft product to its original container. Bearing In Hopper 2. Wash spreader thoroughly after each use and dry completely in sun or heated area. 3. Oil the axle bearings, impeller shaft bearing in hopper, control knob in T-handle. - Page 8 PARTS LIST FOR MODEL AM50P PARTS LIST FOR MODEL AM50P PARTS LIST FOR MODEL AM50P PARTS LIST FOR MODEL AM50P PART OF OUR SERVICE IS PROVIDING REPLACEMENT PARTS. Parts may be obtained through your local distributor. Be sure to give: 1.