Rack Mounting The Hp E840Xa Using Support Rails; Procedure - HP E840 A Series User And Service Manual

Rack Mounting the
HP E840xA using
Support Rails

Procedure

Figure 2-1. Attaching Handles to the Adapters (Option 923 - kit p/n E8400-80923).
Chapter 2
This section contains instructions for mounting the HP E840xA mainframe
in an EIA cabinet using the HP E3664A support rail kit. The E3664A kit can
be used with any of the rack mount adapter options; however, the E3664A
is only compatible with HP cabinets. The following procedures apply to all
adapters, with adapter-specific information noted where necessary.
Note
If you ordered Cable Tray Option 914, refer to
before rack mounting the mainframe.
1. Attach the handles to the adapters using the m5x10 flat head screws
(Figure 2-1). Handles are included only with the HP E840xA
Standard adapters (Option 923).
m5x10 Flat Head Screws
Rack Mounting and Option Installation
page 34
and install the tray
25