RTS Home Accents Rain Barrel Link Kit Assembly Instructions Manual

These assembly instructions are for the 50 US Gallon Flat Back Rain Barrel, the 55 US Gallon Flat Back Rain Barrel with
Removable Lid, the 35 US Gallon Round Rain Barrel with Planter and the 25 US Gallon Rainwater Shed Collector.

Included with link kit:

1x Clear
Linking Tube
2x Plastic
Hose Clamps
1
Using a 1" spade drill bit, drill a hole in the flat area on
the left or right side of the rain barrel. The hole location
is shown in the image below.
The hole has already been pre-drilled in your 55 US Gallon
Premium Flat Back Rain Barrel with Removable Lid.
5510-00151I-00-00 Rev. 2
Assembly Instructions
Read all instructions before assembly. To watch the video version
of these assembly instructions, visit www.rtshomeaccents.com
WARNING: RTS Home Accents is not responsible for performance of assembled product
Questions? Missing Parts? Call us at 1-888-641-3077 (USA),
1-800-663-2803 (Canada) or email us at wecare@rtscompaniesinc.com
Included with rain barrel:
1x O-Ring
1x Plastic
Hose Barb
Rain Barrel Link Kit
and will assume no liabilities.
1x Plastic Lock Nut
2
Insert the threaded end of the hose barb into the 1"
drilled hole.

Required (Not Included):

1" spade drill bit

Inside the rain barrel

Reach inside the rain barrel
through the screen opening on
the top and place the O-Ring
over the hose barb, flush to the
inside of the rain barrel. Then
screw the plastic lock nut onto
the hose barb until tight.
Drill
page 1 of 2