Page 1
Utility (Race Jug) Adaptor Fuel Jug Adaptors WARNING: PLEASE READ ALL INSTRUCTIONS BEFORE PROCEEDING. PROFLOW WILL NOT BE RESPONSIBLE FOR ANY DAMAGE AS A RESULT OF THE INCORRECT INSTALLATION OF THIS PRODUCT. IT IS RECOMMENDED THAT A QUALIFIED AUTOMOTIVE TECHNICIAN PERFORMS THIS INSTALLATION.
Page 2
SPECIFICATIONS Power Requires 4x “AA” Batteries (NOT Included) Delivery Volume 12 Litres Per Minute Auto-Stop Built In Auto - Stop System Applications Gasoline, diesel, kerosene, light oils, non-drinking water IMPORTANT SAFETY INFORMATION 1. Do not use with corrosive liquids. Not for use with drinking water. 2.
Page 3
OPERATING INSTRUCTIONS Battery Operation 1. Open battery cover by placing thumb on grooves and sliding off in direction of arrow. 2. Insert 4 AA batteries according to “+” and “-“ symbols. Replace all four batteries at the same time and use the same type/brand of batteries. Replace the batteries when motor does not operate, even after pressing ON switch or if transfer rate becomes slower than normal.
Page 4
PUMP OPERATION Do not run unit dry. Make sure suction tube is fully submerged in liquid before turning on. When the transfer is complete, turn the switch off. After use, do not turn pump upside down. Clean unit with cotton cloth and wipe dry. Remove batteries and store in a clean, dry location, out of reach of children.
Page 5
5. Once pump has automatically stopped, bring the discharge hose up above the tank to drain excess liquid back into the supply tank as per Figure 2. CAUTION: MAKE SURE TO REMOVE ANY LEFT-OVER FUEL IN THE PUMP AFTER EACH USE. IF FUEL REMAINS AROUND SENSOR, IT MAY CAUSE PUMP FAILURE.
Page 6
Included Adaptors PROFLOW LIMITED WARRANTY This product is warranted to be free from defects in materials and workmanship for a period of one year from the original date of purchase.
Need help?
Do you have a question about the PFETP-1000 and is the answer not in the manual?
Questions and answers