Table of Contents
Advertisement
PC/AV Mode
Set
PC/AV Mode
to AV. The picture size will be enlarged.
This option is useful when you view a movie.
•
Set to
PC
when connected to a PC.
•
Set to
AV
when connected to an AV device.
― If the monitor (when set to HDMI1, HDMI2, DisplayPort) is in power saving mode or is displaying the
message
Check Signal
Cable, press the
or AV.
DisplayPort Ver.
Select your Displayport.
― Incorrect settings may cause the screen to go blank. If this occurs, check the device specifications.
― If the monitor (when set to HDMI1, HDMI2, DisplayPort) is in power saving mode or is displaying the
message
Check Signal
Cable, press the
or 1.2.
Source Detection
Select either
Auto
or
Manual
as the method to recognize input signal.
― Not available when
PIP/PBP Mode
is set to On.
icon to display the On Screen Display (OSD). You can select
icon to display the On Screen Display (OSD). You can select
Key Repeat Time
Control the response rate of a button when the button is pressed.
Acceleration,
1
sec, or
2 sec
can be selected. If
when a button is pressed.
Power LED On
PC
Configure the settings to enable or disable the power LED located at the lower part of the product.
•
Working: The power LED is on when the product is turned on.
•
Stand-by: The power LED is on when the product is turned off.
Reset All
1.1
Return all the settings for the product to the default factory settings.
No Repeat
is selected, a command responds only once
38
Advertisement
Table of Contents
