Uv-C Bulb Replacement; Cleaning; Troubleshooting - Pure Enrichment PUREZONE TURBO User Manual

FILTER REPLACEMENT (CONT.)
6. Insert new filter. Secure, then return the base and twist RIGHT to
lock.
7. Reset the filter indicator by pressing and holding the Filter Reset
button for 3 seconds.The red indicator light will turn off.
NOTE: When the filter expires, the system will send notification to
remind the user to replace the filter. When the filter is not installed or
the bottom cover is opened, the unit will shut off automatically.

UV-C BULB REPLACEMENT

Replace the bulb according to the directions below.
1. The UV-C bulb is located in a compartment
in the center of the purifier. To access, first
follow the instructions to remove the filter.
2. After removing the filter use a screwdriver to
remove two screws and detach the UV bulb
enclosure.
3. Hold the unit in place with one hand. Locate
the bulb and reach into the cylinder.
4. Turn the bulb in a counter-clockwise direction
(left) to loosen from the socket.
5. Take new bulb and screw into unit using a
clockwise motion. Wipe off fingerprints with a
dry cloth.
6. Reassemble by reversing steps 1&2. Turn the
unit back on.
NOTE: DO NOT look directly at the UV light when
UV-C is turned on.
16
CLEANING & MAINTAINING THE AIR PURIFIER
1. Unplug before cleaning.
2. Wipe the outside of the air purifier with a soft, dry cloth. If
needed, wipe the housing with a damp cloth, then immediately
dry.
3. Vacuum the inside of the air purifier.
4. Do not clean with abrasive chemicals or flammable cleaning
agents.
CLEANING & MAINTAINING THE FILTER
The filter should be cleaned once a month to increase the efficiency
and extend the life of your filter. Clean the inside and outside of the
filter using a soft brush or vacuum hose to remove hair, dust, and
large particles. Do not clean the filter with water or other liquids.
NOTE: The filter is not washable. DO NOT wet the filter when

cleaning.

TROUBLESHOOTING

Problem Solution
Unit is not Check to make sure PureZone Turbo is properly
powering on plugged in and the electrical outlet is working.
Check that the base is latched firmly in place.
Check that the filter is firmly in place.
Decreased air Check that the filter is clean, replace if necessary.
flow
Check for any obstructions in the air inlet and
outlet.
Excessive Check for and remove any foreign objects in
noise contact with the fan.
The filter may be clogged and ready for
replacement, replace if necessary.
Uneven positioning. Reposition on an even surface.
If your problem is not resolved by the solutions listed above, contact
Pure Enrichment for assistance by emailing help@pureenrichment.
com.
17