Philips AJ6110 Quick Start Manual page 3

Mount it
3
Ask a friend to help out. An extra hand to hold
the unit makes mounting easier and quicker
A
•
Cut the template to fit inside the cabinet.
•
Align the template border marked "FRONT" along the
front edge of your cabinet.
•
Use adhesive tape to fix the template.
•
Drill 1/4 inch holes, as marked X on the template.
•
Remove the template when you finish drilling.
Tip
– Clean the bottom of the cabinet surface and also empty your cabinet before mounting.
– Place the unit in a clean, safe place when drilling to avoid wood shavings dropping into the
ventilation slots.
– Use a nail to start each drill hole.
– Drill from the bottom upwards if you do not have enough room inside the cabinet.
– Hold your drill firmly at 90 o with the cabinet bottom and drill holes at low speed.
– Clear wood shavings.
B
Using the spacers
On the spacers, there are 4 pairs of notch length
options. Depending on the thickness of you cabinet bot-
tom (with/ without an overhang), these notch lengths
correspond to the 4 notch height in the space holders,
and allow you to adjust to the best height to help you
mount the unit.
•
Measure the height of the cabinet bottom and/over-
hang.
•
Turn the spacer counterclockwise to determine
which of the 4 heights is most suitable: Low • •
High. Align to the arrow indication.
•
Insert the spacers accordingly.
A
Template
B
Spacer
L (Low)
L••H (4 heights)
Arrow
C
•
Manually fasten the 4 long screws down into the spacer holder holes to mount your set. Start
screwing at opposite corners of the unit for better support.
Tip
To prevent damage to your
set, do not use an electric
drill to secure screws when
mounting!
– If the overhang is more than 1 1/4 inch, use
longer screws (not included).
C