Table of Contents
Advertisement
the device will start normally; the device power adapter requires 12-16V,
2A.
Be careful not to short the positive and negative wiring, otherwise the device will not
start.
If you do not need to install the device on the wall, you can directly refer to step 6. After
the device is powered on, start using the device.
2. Place the hole paper on the wall, keep the horizontal line parallel to the ground when
pasting, and the red line is 1.4m away from the ground.
3. Drill 3 screw holes in the wall according to the instructions of the hole paper, and open
1-2 threading holes according to the wiring requirements, and insert the rubber plugs in
the accessories into the holes.
12/ 34
Advertisement
Table of Contents
