Numeric Error Codes - Lenovo ThinkPad X1 Extreme Gen 5 Hardware Maintenance Manual

Numeric error codes

Table 1. Numeric error codes
Symptom or error
0177
Bad SVP data, stop POST task—The checksum of the
supervisor password in the EEPROM is not correct.
0183
Bad CRC of Security Settings in EFI Variable. Enter the
ThinkPad Setup program.
0187
EAIA data access error—The access to EEPROM is failed.
0188
Invalid RFID Serialization Information Area.
0189
Invalid RFID configuration information area—The
EEPROM checksum is not correct.
0190
Critical low-battery error
0191
System Security—Invalid Remote Change requested.
0199
System Security— Security password retry count
exceeded.
0270
Real Time Clock Error— System Real Time Clock is not
functional.
0271
Check Date and Time settings— Neither the date nor the
time is set in the computer.
1802
Unauthorized network card is plugged in—Turn off and
remove the network card.
1820
More than one external fingerprint reader is attached.
Power off and remove all but the reader that you set up
within your main operating system.
2101
Detection error on SSD1 (M.2)
2102
Detection error on SSD2 (M.2)
2111
Read error on SSD1 (M.2)
2112
Read error on SSD2 (M.2)
36
P1 Gen 5 / X1 Extreme Gen 5 Hardware Maintenance Manual
FRU or action, in sequence
System board
1. Run the ThinkPad Setup program, and then save
current setting by pressing F10.
2. System board
System board
System board
System board
1. Charge the battery.
2. Battery
1. Run the ThinkPad Setup program, and then save
current setting by pressing F10.
2. System board
1. Run the ThinkPad Setup program, and then save
the current setting by pressing F10.
2. System board
Have the computer serviced.
Set the date and time, using ThinkPad Setup.
1. Remove wireless network card.
2. System board
Remove all but the reader that you set up for the
authentication.
1. Reseat the M.2 solid-state drive.
2. M.2 solid-state drive
3. System board
1. Reseat the M.2 solid-state drive.
2. M.2 solid-state drive
3. System board
1. Reseat the M.2 solid-state drive.
2. M.2 solid-state drive
3. System board
1. Reseat the M.2 solid-state drive.
2. M.2 solid-state drive
3. System board