Table of Contents
Advertisement
Inspection, Maintenance, and Cleaning
Procedures not specifically explained in this manual must
be performed only by a qualified technician.
Do not use damaged equipment. If abnormal noise, vibration, or
leaking air occurs, have the problem corrected before further use.
Follow all guidelines regarding chemicals sprayed, including MSDS instructions and EPA regulations.
Release pressure in Bottle by depressing Trigger or Valve Stem.
Contents are under pressure and may spurt forcefully.
1. BEFORE EACH USE, inspect the general
condition of the Sprayer. Check for:
• loose hardware
• misalignment or binding of moving parts
• cracked or broken parts
• any other condition that may
affect its safe operation
Troubleshooting
Problem
Unit does not spray
Spray pattern is
undesirable
Follow all safety precautions whenever diagnosing or servicing the Sprayer.
Record Product's Serial Number Here:
Note: If product has no serial number, record month and year of purchase instead.
Note: Some parts are listed and shown for illustration purposes only, and are not available
individually as replacement parts. Specify UPC 193175473745 when ordering parts.
Page 6
Possible Causes
1. Not enough liquid in Bottle.
2. Filler Cap is loose.
3. Sprayer not pressurized.
4. Nozzle is clogged.
1. Nozzle needs adjustment.
2. Spray fluid contains
particles or sand.
3. Nozzle is clogged.
For technical questions, please call 1-888-866-5797.
2. AFTER EVERY USE, clean the Sprayer:
a. Follow chemical manufacturer's
clean up instructions
b. Allow to air-dry.
3. PERIODICALLY, lubricate all moving parts
of the Sprayer with petroleum jelly.
4. Store the Sprayer in a safe, dry, clean location
out of reach of children and out of sunlight.
Likely Solutions
1. Add liquid to Bottle (fill 2/3 max).
2. Tighten Filler Cap.
3. Place air chuck (sold separately) on Valve
Stem to charge Bottle to 80-150 PSI.
4. Disassemble, clean, then reassemble Nozzle.
1. Remove Spray Nozzle (2) to
change to a Pin Stream.
2. Disassemble, clean, then reassemble
Nozzle. Empty, clean, then refill
bottle with properly strained fluid.
3. Disassemble, clean, then reassemble Nozzle.
Item 59544
Advertisement
Table of Contents
