Fujitsu LIFEBOOK E547 User Manual page 38

Installing memory module
To install memory, perform these steps.
Before installing any memory module,
remember to power off the notebook and
disconnect the AC adapter from it.
Keep small objects, such as a cover,
caps and screws, out of the reach of
babies and children. These small objects
may suffocate a baby or child if they are
swallowed accidentally. Should such
an accident happen, consult a doctor
immediately.
Certain components around the memory
slots are very hot when the notebook is
powerd on for a long period of time.
To avoid possible burns, do not install or
remove memory module immediately after
turning off the notebook. Wait for a while
until its internal components cool down.
To install or remove a memory module,
hold it by the edge and be careful not to
touch any component and IC chip.
Memory module is made of materials
sensitive to human body static charges.
Before handling a memory module,
always touch an appropiate metal object to
discharge static charges from your body.
Please remember to turn off the notebook
before you begin to install or remove a
memory module. If the notebook is placed
in standby or hibernate mode while the
memory is removed, data may be lost
or corrupted. This may also damage the
memory module.
Explicit Self-install
1. Turn off the notebook and disconnect the
AC adapter from it.
2. Close the LCD panel and place the
notebook upside down.
3. Remove the screws (two) securing the
memory compartment slot cover and
remove it.
Remove the battery compartment cover at
the bottom of the notebook.
Memory compartment cover
4. Install the memory module
Insert the memory module into the slot with
the notch in the memory module aligned
with the projection on the connector, and
push the memory module down unit it locks
in place with a click sound.
Notch in the module
25