Table of Contents
Advertisement
Transport Height Adjustment
Transport height is adjusted to stabilize the mower in
the up, locked position.
1.
Raise attachment lift lever all the way to the
latched position. Check if bumpers, on rear of
mower draft bars contact under footrests.
2.
Adjust lift chain by turning trunnion on eyebolt
in rear hole of tractor lift (Fig. 12). Turn
trunnion clockwise to raise or counterclockwise
to lower mower.
3.
Transport level stops are normally in the bottom
of the slot, however they can be adjusted up for
side-to-side level when extra weight from a grass
catcher is on one side (Fig. 12).
2
Figure 12
1. Bumper
2. Trunnion
1
m–2813
3
3. Leveling bolts
Removing the Mower
1.
Park the machine on a level surface, disengage
the power take off (PTO), set the parking brake,
and turn the ignition key to "OFF" to stop the
engine. Remove the key.
2.
Remove the two wing nuts and belt cover from
the tractor (Fig. 13).
2
Figure 13
1. Belt cover
3.
Turn knob on idler assembly clockwise to loosen
belt. Remove belt from upper mower pulley
(Fig. 14).
2
Figure 14
1. Knob
Assembly
2
1
m–2534
2. Wing nut
1
m–2823
2. Upper mower pulley
9
Advertisement
Table of Contents
