Replacing carbon brushes
1
001146
When the resin insulating tip inside the carbon brush is
exposed to contact the commutator, it will automatically
shut off the motor. When this occurs, both carbon
brushes should be replaced. Keep the carbon brushes
clean and free to slip in the holders. Both carbon brushes
should be replaced at the same time. Use only identical
carbon brushes.
Use a screwdriver to remove the brush holder caps. Take
out the worn carbon brushes, insert the new ones and
secure the brush holder caps.
1
2
006780
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers, always
using Makita replacement parts.
ACCESSORIES
CAUTION:
These
accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to
persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Wheel guard (Wheel cover)
•
Inner flange
•
Depressed center wheels
•
Lock nut (For depressed center wheel)
•
Rubber pad
•
Abrasive discs
•
Lock nut (For abrasive disc)
•
1. Commutator
2. Insulating tip
2
3. Carbon brush
3
1. Brush holder cap
2. Screwdriver
or
attachments
Only use
accessory or
Lock nut wrench
•
Cut-off wheels
•
Inner flange (For cut-off wheel)
•
Outer flange (For cut-off wheel)
•
Wire cup brush
•
Side grip
•
Dust collecting wheel guard
•
are
9