Page 1
50L STAINLESS STEEL WET/DRY VACUUM 5 year limited warranty on tool 120V 60HZ 8.5AMP Not suitable for ultra-fine dust collection such as drywall dust. Such use will void the warranty. 5002219 JN308...
PRODUCT SPECIFICATIONS 50L STAINLESS STEEL WET/DRY VACUUM Voltage 120V~ 60Hz Rated Power 8.5A 6.5Peak HP Tank Capacity 13Gal (50L) Flexi Hose 1 1/4 in x 5 ft (32mm x 1.5m) Flow rate 60 CFM Power cord 13.13 ft (4m) Replacement cartridge filter 1277-035 Replacement collection bag 1277-033...
GENERAL SAFETY WARNINGS IMPORTANT SAFETY INSTRUCTIONS Read and understand all safety and operational instructions. Failure to follow the safety rules listed below and other basic safety precautions may result in serious personal injury. Keep this manual, sales receipts, and applicable warranty forms for future reference.
Page 5
1277-027 50L STAINLESS STEEL WET/DRY VACUUM When using this Wet/Dry Vacuum follow basic safety precautions including the following: To reduce the risk of fire, electric shock or injury: • Do not run the Wet/Dry Vacuum unattended. • Do not vacuum, or use this Wet/Dry Vacuum near liquids, gases, or explosive vapours like gasoline or similar fuels, lighter fluid, cleaners, oil based paints,...
This Wet/Dry Vacuum is double-insulated, eliminating the need for a separate grounding system. Use only identical replacements parts. Read the servicing instructions before servicing the Wet/Dry Vacuum. Use this Wet/Dry Vacuum only as described in this manual. Observe the following warnings that appear on the motor housing of this Wet/Dry Vacuum.
Page 7
1277-027 50L STAINLESS STEEL WET/DRY VACUUM Servicing of Double-Insulated Wet/Dry Vacuum – Continued Warning For your own safety, read and understand this instruction manual. Do not operate unattended. Do not use this Wet/Dry Vacuum to pick up hot ashes, coals, toxic, flammable or other hazardous materials. Do not use near explosive liquids or vapours.
KNOW YOUR WET/DRY VACUUM WARNING Attention Before starting please read, understand, and apply the safety instructions. Reminder: DO NOT vacuum hazardous substances. FUNCTIONS 1. Handle 2. Power switch 3. Lid Latches 4. Vacuum port 5. Dust tank 6. Dolly 7. Casters 8.
Page 9
1277-027 50L STAINLESS STEEL WET/DRY VACUUM Know Your Wet/Dry Vacuum – Cont’d ATTENTION Read the entire important safety information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
Page 10
DRY PICK-UP 1. The filter must always be in correct position to reduce the risk of leaks and possible damage to the vacuum. Make sure that the filter is completely covering the filter cage. Make sure there are no gaps between the filter and the lid.
Page 11
1277-027 50L STAINLESS STEEL WET/DRY VACUUM WET PICK-UP 1. Install a foam filter over the filter basket. NOTE: Wet pick-up accessories should be washed periodically, especially after picking up wet, sticky kitchen accidents. This can be accomplished with a warm solution of soap and water.
EMPTYING THE TANK WARNING To reduce the risk of injury from accidental starting, unplug power cord before emptying the dust tank. FOR DRY USE 1. Remove the power head assembly of the wet/dry vacuum by pulling power head assembly. 2. Dump the tank contents into the proper waste disposal container. FOR WET USE Take down the exhaust water pipe from the hook, the liquid of the tank will drain from it.
1277-027 50L STAINLESS STEEL WET/DRY VACUUM MAINTENANCE WARNING To reduce the risk of injury from accidental starting, unplug power cord before changing or cleaning filter. The filter should be cleaned often to maintain peak Vacuum performance. Do not remove filter cage and float. The float prevents water from entering the impeller and damaging the motor.
TROUBLESHOOTING WARNING Minor problems often can be fixed without calling customer service. PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION Vacuum will not run No electricity Make sure electrical outlet has voltage (A qualified electrician may need to be contacted) Loss of suction, 1.
Any attempt to repair or replace electrical parts on this wet / dry vacuum may create a safety hazard unless repairs are performed by a qualified technician. PARTS LIST Key # Part # Part Name Quantity 1277-027-001 Handbar screw 4 x 16 1277-027-002 Handbar 1277-027-003 Cord Sleeve 1277-027-004...
Page 17
1277-027 50L STAINLESS STEEL WET/DRY VACUUM Parts List – Continued Key # Part # Part Name Quantity 1277-027-031 Screw 4 x 16 277-027-032 Clamps sets 1277-027-033 Vacuum-inlet sealing ring 1277-027-034 Vacuum-inlet assembly 1277-027-035 Vacuum-inlet screw 4 x 16 1277-027-036 Water outlet base threaded ring...
WARRANTY 50L STAINLESS STEEL WET/DRY VACUUM If this Benchmark tool fails due to a defect in material or workmanship within five years from the date of purchase, return it to any Home Hardware store with the original bill of sale for exchange. 3-year warranty for the battery and charger.
Need help?
Do you have a question about the 1277-027 and is the answer not in the manual?
Questions and answers