Controls; Control Panel Removal; Control Adjustments - Rheem Raypak 207A Installation And Operation Manual

7. CONTROLS

CONTROL
MANUAL
BEZEL
RESET
ROLL-OUT
SWITCH
GAS
VALVE
PILOT
AIR PRESSURE
SWITCH
Figure 35. Location of Controls (View One)
DRAIN PLUG IN
REAR HEADER
Figure 36. Location of Controls (View Two)

Control Panel Removal

1. Remove screw from front door. Set aside door for
serviceability.
2. Remove (4) screws from sides of control panel.
3. Rotate control panel down until panel stops. Do not
force.
22
PRESSURE SWITCH
TEMP SENSOR
HL1 - HIGH LIMIT
HL2 - HIGH LIMIT
UNITHERM
GOVERNOR
Figure 37. Knurled Screw Location
PROTEK
SHIELD

Control Adjustments

ASSY
F10639-3
The pool heater touchpad, located on the upper front
panel of the heater, allows the user to select either POOL
or SPA operation, and to adjust the setpoint temperature.
The LCD display window indicates the mode (OFF, SPA,
POOL) and the actual water temperature. A manual power
switch provided below the touchpad turns the control
power ON or OFF. See Figure 38.
BLOWER
F10639-2
Figure 38. Control Adjustments
NOTE: Caution must be used to not damage controls
or wiring.
TEMP ADJUST BUTTONS
LCD DISPLAY
KNURLED
SCREW
F10647-3
MODE BUTTON
TEMP
MODE
ON
OFF