Table of Contents
Advertisement
Pre-Maintenance
Procedures
Raising the Seat
Ensure that the parking brake is engaged. Lift the
seat forward.
You can access following components by raising the
seat:
•
Serial plate
•
Service decal
•
Seat-adjustment bolts (if applicable)
•
Fuel filter
•
Battery and battery cables
Lubrication
Greasing the Bearings
Service Interval: Every 25 hours—Grease all the
lubrication points.
Grease Type: No. 2 lithium grease
1.
Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake; refer to
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Clean the grease fittings
29) with a rag.
Note:
Scrape any paint off the front of the
fitting(s).
1. Front caster tire
Located on the seat-pan underside
1. Read the instructions
before servicing or
performing maintenance
2. Check the tire pressure
every 25 operating hours
4.
Connect a grease gun to each fitting
and
Figure
29).
5.
Pump grease into the fittings until grease begins
to ooze out of the bearings.
6.
Wipe up any excess grease.
30
Park Position (page
13).
(Figure 28
and
Figure 28
Figure 29
3. Grease every 25 operating
hours
4. Engine
(Figure 28
Figure
g032432
decal106-8717
Advertisement
Table of Contents
