Advertisement
Quick Links
UK-electronic ©2013
Manual to build a Unicord SuperFuzz Clone
Page 2..............................................Basics
Page 3..............................................Bill of material
Page 4...5.........................................Soldering the pcb
Page 6..............................................Offboard wiring
Page 7..............................................Notes
Page 8...10.......................................Wiring, Drill template, foil template 1590B
Page 11............................................Schematic
Some connections of importend components
2013 © UK-electronic
Advertisement
Related Manuals for UK-electronic Unicord SuperFuzz Clone
Summary of Contents for UK-electronic Unicord SuperFuzz Clone
- Page 1 UK-electronic ©2013 Manual to build a Unicord SuperFuzz Clone Page 2..........Basics Page 3..........Bill of material Page 4...5.........Soldering the pcb Page 6..........Offboard wiring Page 7..........Notes Page 8...10........Wiring, Drill template, foil template 1590B Page 11..........Schematic Some connections of importend components 2013 © UK-electronic...
- Page 2 Color table for resistors MF207 FTE52 1% and a example 2013 © UK-electronic...
- Page 3 Resistor 100K (brown/black/black/orange/brown) Resistor 150K (brown/green/black/orange/brown) Resistor 220K (red/red/black/orange/brown) Resistor 470K (yellow/violet/black/orange/brown) Resistor 1M (brown/black/black/yellow/brown) Cermet Trimmer 10K (103) Capacitors capacitor 1nF MKT capacitor 2,2nF MKT capacitor 100nF MKT Electrolytic cap RASM 10µF/25 or 50V Elektrolytic cap RASM 100µF/16 2013 © UK-electronic...
- Page 4 Moreover one should start to equip with the lowest components, i.e. as the first the resistors, the diodes, the capacitors and at last the transistors. As the last one solders from approx. 6 to 8 cm long Litzen in the holes of the Potis. (Easier from the bottom side) 2013 © UK-electronic...
- Page 5 This solder is conveniently right from the bottom of the corresponding points. The attachment of the circuit board in the enclosure by means of the supplied self-adhesive spacer directly on the two two potentiometer.. 2013 © UK-electronic...
- Page 6 Wiring - diagram 2013 © UK-electronic...
- Page 7 For self-drill: Potentiometer: 7mm Jacks: 9.3mm 3PDT switch: 12mm DC jack: 12mm LED bezel and SPDT switch: 6mm If clean up and properly wired, the effects device should work immediately. For any questions we are always available. 2013 © UK-electronic...
Need help?
Do you have a question about the Unicord SuperFuzz Clone and is the answer not in the manual?
Questions and answers