Medisana 51130 Manual page 20

GB
2 Useful Information / 3 Getting Started
3.1
Inserting /
removing batteries
3.2
Using a Mains
Adaptor
3.3
Setting time
and date
14
• If the systolic and diastolic readings seem unusual (too high or too low) on
several occasions, despite correct use of the unit, please inform your doctor.
This also applies to the rare occasions when an irregular or very weak pulse
prevents you from taking readings.
Insertion: Open the battery compartment on the underside of the unit by
exerting gentle pressure, and insert the four batteries included with the unit
(alkaline batteries, AA type, LR 6). Remember to insert the batteries as indi-
cated in the diagram in the battery compartment. Replace the lid, pressing it
until it snaps into place.
Removal: When the battery symbol
place the batteries with new ones.
After batteries be inserted, the display will display the defaulted date & time.
Set the date and time as described in 3.3 Set Date and Time. Please note that
the date and time will have to be reset each time new batteries are inserted.
The previous measuring results are saved.
BATTERY SAFETY INFORMATION
• Keep away from children!
• Do not short-circuit!
• Do not dispose of old batteries with your household waste,
but dispose of them at a battery collection station at a
recycling site or in a shop!
Alternatively, the unit may also be operated with a special power adapter
(MEDISANA item no. 51125), which is plugged into the connector
on the right-hand side of the unit. In this case the batteries remain in the unit.
The batteries are disconnected mechanically when the connector is inserted on
the right-hand side of the blood pressure monitor. It is necessary, therefore, to
plug the mains adaptor into the mains socket first of all and then to connect it
to the blood pressure monitor. If the blood pressure monitor is no longer being
used, first remove the connector from the blood pressure monitor and then pull
the mains adaptor out of the mains socket. Doing this means that the date and
time will not have to be reset each time.
1. The date and time can be set with the device switched off. Press the START
button and the MEM button
the display (flashing). To change the month, press the MEM button
repeatedly until the required value is displayed. The value auto-repeats if
the MEM button
displays the values for month, day, hour and minute (flashing). Press the
MEM button to change the values.
2. After the fifth press of the START button
stop flashing. The time setting is now complete.
3. The date and time must be reset if the batteries are replaced.
appears in the display, please re-
• Do not recharge!
• Do not throw into fire!
simultaneously. The month appears on
is held down. Pressing the START button
provided
again
the numbers in the display