Table of Contents
Advertisement
Power requirements
9V BATTERY
To operate the Dr. Robert Unknown Pleasures Ltd. Edition
with a 9V battery you'll have to follow the next steps:
Loosen the side thumb screws and disassemble the
1
Smart Track
®
system of both sides of the pedal.
10
Remove the screws of the baseplate to access the
2
inside of the pedal.
Put the 9V battery in the position showed in the
3
diagram. Make sure to use a good quality alkaline
battery to ensure the longest time of operation.
9V BATTERY
Tight back the lid with the 4 screws and reassembly
4
the Smart Track
®
system.
CAUTION:
If used improperly, batteries may explode or leak
and cause damage or injury.
- The use of an incorrect type of battery can void the
safeguard mechanisms of the device (for example, in the
case of some lithium battery types)
- Batteries must never be recharged, heated, taken apart,
or thrown into fire or water.
- Do not expose the unit to extremely high temperatures,
direct sunlight or other devices that radiate heat, as it may
lead to an explosion or leakage of flammable liquid or gas.
POWER SUPPLY
This unit can be powered with a 9VDC negative tip power
supply with the standard Boss type 2.1mm connector.
Current supply should be a minimum of 100 mA just to
leave a safety margin for the DC adapter.
Make sure you use a good quality power supply and avoid
using generic SMPS type adapter which can induce high
pitched noise to the audio.
11
Advertisement
Table of Contents
