Table of Contents
Advertisement
en Meat probe
10.3 Setting the timer
The timer runs independently during the operation. You
can set the timer for up to 24 hours. The timer has its
own signal so that you can tell whether it is the timer or
a cooking time that has elapsed.
Press .
1.
To set the timer, press the relevant time value on
2.
the display, e.g. minute display "m" or second dis-
play "s".
a The selected value is marked in blue.
Set the timer using the setting ring.
3.
If required, use
to reset the setting value.
4.
To start the timer, press
a The timer counts down.
a The timer remains visible on the display if the appli-
ance is switched off.
11 Meat probe
Cook with precision by inserting the meat probe
the food and setting a core temperature on the appli-
ance. The meat probe measures the core temperature
inside the food. Once the set core temperature has
been reached in the food, the appliance automatically
stops heating.
11.1 Suitable types of heating with the meat
probe
Only certain types of heating are suitable for use with
the meat probe.
You can use the meat probe with the following types of
heating:
¡ 4D hot air
¡ Top/bottom heating
¡ Gentle hot air
¡ Gentle top/bottom heating
¡ Circulated air grilling
¡ Pizza setting
¡ Slow cooking
¡ Bottom heat
¡ Keeping warm
11.2 Inserting the meat probe
Use the meat probe supplied or order a suitable meat
probe from our customer service.
WARNING ‒ Risk of electric shock!
Using the wrong meat probe could damage the insula-
tion.
Only use the meat probe for this specific appliance.
▶
14
on the display.
into
a When the appliance is switched on, the display
shows the settings for the current operation. The
timer is displayed in the status display.
a Once the timer has elapsed, a signal sounds. A no-
tification appears on the display confirming that the
timer has finished.
Changing the timer
You can change the timer at any time.
If the timer is running in the background, use
1.
select the timer beforehand.
Press .
2.
Change the timer using the setting ring.
3.
4.
Press
to confirm.
Cancelling the timer
You can cancel the timer at any time.
If the timer is running in the background, use
1.
select the timer beforehand.
Press .
2.
Reset the timer using
3.
4.
Press
to confirm.
ATTENTION!
Otherwise the meat probe may be damaged.
Do not trap the cable of the meat probe.
▶
To prevent the meat probe from being damaged by
▶
excessive heat, there must be a gap of a few centi-
metres between the grill element and the meat
probe. The meat may expand during the cooking
process.
Note: If the pull-out rails are attached at level 3, you
cannot insert the roasting sensor in the cooking com-
partment. Unhook the pull-out rails or hook them in at a
different level.
→ "Rails", Page 28
Insert the meat probe into the food.
1.
The meat probe has three measuring points. Ensure
that at least the middle measuring point is inserted
in the food.
Thin
Insert the meat probe into the thickest
pieces
part of the meat from the side.
of meat
Thick
Insert the meat probe diagonally into the
pieces
meat from above, pushing it in as far as
of meat
possible.
Note: If you want to turn the food, insert
the meat probe into the side of the food
so that it does not need to be removed
when turning.
.
to
to
Advertisement
Table of Contents
