Memory module
Prerequisite
Before you start, read Generic Safety and Compliance Notices and print the following instructions.
Attention: Do not touch the contact edge of the memory module. Otherwise, the memory module might get
damaged.
Replacement procedure
Note: If you only install one memory module, install it in memory slot
To replace a memory module, do the following:
1. Disable the built-in battery. See "Disable the built-in battery" on page 27.
2. Turn off the computer and disconnect the computer from ac power and all connected cables.
3. Close the computer display and turn over the computer.
4. Remove the base cover assembly. See "Base cover assembly" on page 28.
a
.
.
Chapter 6
CRU replacement
31