Lakeside Extension Kit 7.5 Manual

M4

Advertisement

Extension Kit 7.5 (M4)
Assembly & Use Instructions
p/n: 000008
Lakeside Recreation LLC
www.lakesiderecreation.com

IMPORTANT NOTE ABOUT STAINLESS FASTENERS

Stainless fasteners may gall and seize up (cold weld) if assembled without lubrication. Be sure to apply a dab of the
supplied anti-seize compound to the threads of each stainless bolt prior to assembling the nut.

Assembly

If the Shore Ramp is not yet assembled, reference these instructions to incorporate the Extension Beam in between the
Keel Beam and Front beam as you assemble the Shore Ramp.
If the Shore Ramp is already assembled, start by removing the 8 bolts on the Keel Beam (rearward end) of the two
Connector Plates that attach the Keel Beam to the Front Beam. The Extension beam will be inserted between these two
sections. Retain the fasteners for re-use.
1. Unpack the Extension Kit box (and the Shore Ramp box) and confirm that all the parts are present according to the
2. Lay the Keel Beam, Extension beam, and Front Beam on a flat surface end to end, with the bottom access openings
facing up. Assemble them together using the Connector Plates, and 32 sets of 1.00" 3/8-16 bolts, washers, and nuts.
Note that 16 sets of bolts, washers, and nuts are supplied with the Shore Ramp Kit, and 16 more with the Extension Kit.
Get all the bolts inserted and the nuts started before tightening any of them. Tighten all 32 sets of fasteners firmly.
Extension Kit
p/n: 000008 rev A
1
doc: 400009 copyright© 2019 Lakeside Recreation, LLC

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Extension Kit 7.5 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Lakeside Extension Kit 7.5

  • Page 1 Note that 16 sets of bolts, washers, and nuts are supplied with the Shore Ramp Kit, and 16 more with the Extension Kit. Get all the bolts inserted and the nuts started before tightening any of them. Tighten all 32 sets of fasteners firmly. Extension Kit p/n: 000008 rev A doc: 400009 copyright© 2019 Lakeside Recreation, LLC...
  • Page 2 PWC tipping to the side. CAUTION: Do not use the Shore Ramp on loose rock or any unstable ground where it may slide down or tip to the side. Extension Kit p/n: 000008 rev A doc: 400009 copyright© 2019 Lakeside Recreation, LLC...
  • Page 3 One Year Limited Warranty LAKESIDE RECREATION products are warranted to be free from defects in materials or workmanship for one (1) year from the date of purchase. Within this period we will provide a replacement for any component that fails in normal use. Such replacement will be made at no charge to you, provided that you shall be responsible for any shipping charges and labor for replacement of the component.

Table of Contents