Lakeside 000010 Assembly & Use Instructions

Shore Ramp DIY Wood Kit
Assembly & Use Instructions
p/n: 000010
Lakeside Recreation LLC
www.shoreramp.com

Additional Materials Needed

The Shore Ramp DIY Kit is designed to be assembled using pressure-treated lumber purchased separately by the
customer from a local lumber yard or home improvement store such as Home Depot, Menards, Lowes, etc.
The Kit uses the following quantities and sizes of pressure-treated lumber:
QTY Size
2 2x6
1 2x4
1 4x4

Tools Needed

The following tools will be necessary or useful to fabricate and assemble the Shore Ramp DIY Kit.

Wood Saw with blade suitable for cross cutting the 2x4's, the 4x4, and the angled rip cuts in the 2x6's:

3/8" Drill Bit, 3/4" Drill Bit, 1-1/8" Drill Bit (Spade style recommended)

Drill

Drill-Guide or a Drill-Press (recommended for uniform, precisely-bored holes).

9/16" box wrench + 9/16" socket wrench.

Rubber mallet.

Medium to large pliers with good gripping teeth (linesman's pliers recommended).

Measuring Tape

Marking Pencil & Straight edge

Square

Clamps

Belt Sander or hand Sanding Block with course sandpaper
Shore Ramp DIY Kit p/n: 000010 rev A
Length
12'
6' (cut into two 3' pieces)
4' (likely need to purchase 8' and cut)
1 doc: 400010 copyright© 2022 Lakeside Recreation, LLC