Home Connect; Setting Up Home Connect; Switching On The Con- Nection To The Wlan Home Network (Wi-Fi) - Bosch KGN56 Series Information For Use

Hide thumbs Also See for KGN56 Series:
Table of Contents

Advertisement

Available languages

Available languages

Switch on Super freezing before
placing large quantities of food in
the appliance.
¡ The freezer compartment door is
open for too long.
Check whether the frozen food has
defrosted or thawed.
Switching off the temperature
alarm
Press
.
a The warning tone is switched off.
Home Connect
10 Home Connect
This appliance is network-capable.
Home Connect
Connect your appliance to a mobile
device to control its functions via the
Home Connect app.
The Home Connect services are not
available in every country. The avail-
ability of the Home Connect function
depends on the availability of
Home Connect services in your coun-
try. You can find information about
this at: www.home-connect.com.
To be able to use Home Connect,
you must first set up the connection
to the WLAN home network (Wi-Fi
and to the Home Connect app.
After switching on the appliance, wait
at least 2 minutes until internal
device initialisation is complete. Only
then should you set up Home Con-
nect.
The Home Connect app guides you
through the entire login process. Fol-
low the instructions in the Home Con-
nect app to configure the settings.
Tips
¡ Please consult the documents sup-
plied by Home Connect.
1
Wi-Fi is a registered trademark of the Wi-Fi Alliance.
¡ Please also follow the instructions
in the Home Connect app.
Notes
¡ Please note the safety precautions
in this instruction manual and
make sure that they are also ob-
served when operating the appli-
ance via the Home Connect app.
→ "Safety", Page 39
¡ Operating the appliance on the ap-
pliance itself always takes priority.
During this time it is not possible
to operate the appliance using the
Home Connect app.
10.1 Setting up Home Con-
nect
Requirements
¡ The mobile device supports the
Bluetooth standard 4.2 or higher.
¡ The Home Connect app has been
installed on your mobile device.
Scan the QR code using the
1.
Home Connect app.
1
)
Follow the instructions in the
2.
Home Connect app.
10.2 Switching on the con-
nection to the WLAN
home network (Wi-Fi)
Press
Home Connect en
.
53

Advertisement

Table of Contents
loading

Table of Contents