Reer FMC-S Manual

GENERAL

These mounting instructions contain information about the mounting of the FMC-S column with integrated
mirror on the FMC-CB stand bottom and about their alignment.
For information about the mounting of the stand bottom and the function of the light curtains, please see
the respective mounting and wiring instructions.
ASSEMBLY WITH THE FMC-CB STAND BOTTOM (Fig. 1)
•
Mount the FMC-CB stand bottom on the floor (see mounting instruction for stand bottom).
Please note:
For a correct alignment, please verify that the stand bottom upper surface is even
and horizontal (using a circular spirit level.)
To operate the regulation, act on the three hexagonal nuts B (fig.2) until the perfect
levelness is reached. (Maximum adjustment: 10mm).
If the ground roughness is over 10mm, flush it adequately.
•
Loosen the three socket head screws and remove the washers.
•
Assembly the column to the stand bottom, centering the FMC-S column rotation flange with the
guides of the FMC-CB stand bottom upper plate.
•
Fix the column tightening the three socket head screws and the washers.
8540459 – Rev.3
COLUMN FOR MIRRORS
Figure 1
www.reer.it
FMC-S
3/4