Advertisement
PRODUCT STRUCTURE, CONTENT OF THE BOX
Content of the box:
1.
AnglerSOL Pro 50 light
2.
12 V charger with charging-indicator LED on the adapter (for charging
in a car)
3.
AC charger with charging-indicator LED on the adapter
4.
Stand
5.
Fixing screw & 2 washers
6.
Allen key for adjusting the stiffness of the vertical rotation
Product structure:
ATTENTION! Battery is built-in, non-replaceable!
ATTENTION! The performance of the battery may drop below 0 Celsius, and
above 40 Celsius temperatures.
ATTENTION! When using or storing your light, please always keep the protective
rubber cover of the charging port well attached to the port (if the port is
currently not in use)!
4
1. Instructions, and information about using the battery, and
maximizing its life span
ATTENTION! The life span of the battery depends on you as well! Please
keep using the product as described in this manual to maximize its life
span for your pleasure:
•
Whenever you turn off your light after use, please make sure that
the battery did not run low. If that happens (the light indicates low
voltage by decreasing the luminosity), please load the battery!
•
It is recommended to full-charge the light before use!
•
If you do not use your light for a longer period, please always pay
attention to full-charge the battery ONCE A MONTH! The light can be
stored on the shelf for another month after that. A long-term storage
of the light with totally discharged battery may significantly reduce
the life span of the battery, or may damage the battery!
ATTENTION! THE STANDBY OPERATION OF THE LIGHT CONSUMES
BATTERY CHARGE AS WELL, WHICH MEANS THAT THE BATTERY IS
BEING DISCHARGED SLOWLY EVEN WHEN YOU DO NOT USE YOUR
LIGHT! THAT IS WHY IT IS KEY ESSENTIAL TO KEEP THE ABOVE WRITTEN
INSTRUCTIONS!
2. Instructions for correct charging, information about charging the
battery
a) Charging with AC cable:
•
A red indicator light on the adapter of the charger shows you that your
battery is charging. The indicator light turns green when charging is
finished. Please stop charging when it happens. On the LED panel,
a blinking blue light on the right side indicates that the battery is
charging.
•
Please only use the original cable supplied with the light for charging
the battery!
•
Please do not turn on the light while charging!
•
If the original cable supplied with the light or its adapter is injured, do
not use it for charging!
•
Please do not leave the light on charger for more than 24 hours!
•
Do not disassemble the light!
•
If you do not use your light for a longer period, please pay attention
to charge your light from time to time as written above in chapter 1!
USER INSTRUCTIONS
5
Advertisement
