Table of Contents
Advertisement
4.COMPONENTS ( FIG.1)
1
Battery release catch
2
Charge level indictor
3
Charge level indictor button
5. OPERATION
5.1
Charging the batterypack
Warning ! Only charge in compatible 20V chargers. Use of other chargers may result in fire, damage or serious
personal injury. The battery pack has been shipped in a low charge condition to prevent possible problems.
Therefore, you should charge it until the green LED on the charger comes on.
1) Check that your mains voltage is the same as that marked on the rating plate of the battery charger. Insert
the power plug of the charger into the socket outlet. The RED LED will then begin to light.
2) Insert the battery pack into the battery charger, then the red LED on charger will begin to Green flash light.
3) You will find a label with "Charger indicator" of the LED indicator on the charger.
The battery pack can become a little warm during the charging. This is normal.
If the battery pack fails to charge, check:
Voltage at the power socket
Whether there is good contact at the charging contacts.
Whether the battery pack is warm or not, The battery protection system will not allow the battery to be
charged if the battery temperature is over 40°C after use, allow the battery pack to cool to room
temperature before commencing with the charging.
If the battery pack still fails to charge, send the charging unit and the battery pack to our customer service
center.
Battery pack
FBA20U2
FBA20U4
Charger (Not included)
FFC20U
4
Advertisement
Table of Contents
