Advertisement
QUICK START GUIDE
1. Turn off the AC Power Supply.
2. Connect the LED string between "+" (anode of LED string) and "-" (cathode of LED string).
3. Connect the AC input voltage between the AC terminals ("N" and "L") as shown on the board.
4. Set AC Power Supply to 180V AC input 260V.
5. Turn on the AC Power Supply.
CAUTION:
There is no galvanic isolation on the EVB board. Be careful when doing the test. To prevent damage to
equipments and EVB board, isolation is suggested to either the test equipments or the EVB board.
NOTICE: The information in this document is subject to change without notice. Please contact MPS for current specifications.
Users should warrant and guarantee that third party Intellectual Property rights are not infringed upon when integrating MPS
products into any application. MPS will not assume any legal responsibility for any said applications.
EV4000DS-00C Rev.1.0
10/25/2019
MPS Proprietary Information. Patent Protected. Unauthorized Photocopy and Duplication Prohibited.© 2019 MPS. All Rights Reserved.
EV4000DS-00C 350mA HIGH LINE INPUT WLED DRIVER
www.MonolithicPower.com
6
Advertisement
