Connect A Dvd Player, A Satellite Receiver Or Cable Box - Philips 37PF9731 User Manual

Connect a DVD player, a satellite receiver or Cable box

Tip: if necessary, you can adjust the picture position to the centre of the screen with the cursor keys.
AUDIO
OUT
DISPLAY SYNCHRONIZED
AUDIO
R
OUT
AUDIO
R
IN
Y Pb
HDTV & Progressive
480p, 576p, 720p, 1080i
EXT3
EXT3 :
AUDIO IN
R / L
1
DVD / STB
AUDIO
OUT DISPLAY SYNCHRONIZED
DIGITAL
AUDIO
AUDIO
R L
OUT
OUT
DIGITAL
AUDIO
AUDIO
R L
IN
IN
Y Pb Pr
HDTV & Progressive
480p, 576p, 720p, 1080i
EXT3
EXT3 : EXT3 :
AUDIO IN YPbPr
R / L
1
SAT / STB
DIGITAL
AUDIO
L
OUT
DIGITAL
AUDIO
L
IN
Pr
DIGITAL
EXT3 :
AUDIO
YPbPr
IN
DIGITAL
AUDIO
IN
CABLE
ANTENNA
o
ANTENNA 75
5
4
With Component Video Connectors
1. Connect the three separate component video
cables 1 to the YPbPr jacks on the DVD
player and to the Y, Pb and Pr jacks of
on the TV.
2. Connect the audio cable 2 to the digital out
of the equipment and to the
connector of the TV.
AUDIO IN
3. Select the equipment you have connected in
the Installation menu, Select your connections,
p. 30, and link it to
EXT3
audio in in the same Connections menu.
4. In case of a DVD player with analogue audio,
connect the three separate component video
cables 1 to the YPbPr jacks on the DVD
player and to the Y, Pb and Pr jacks of
on the TV. Connect the audio cable to the
DVD's audio and
L
jack of
AUDIO IN
5. In case of a cable box and/or a satellite
receiver also connect the cable TV cable and/or
the satellite antenna cable 4 and the aerial
cable 5.
Notes:
- cables are often colour coded. Connect red to
red, white to white, etc..;
- the labels for the component video sockets may
differ depending on the DVD player connected.
Although the abbreviations may vary, the letters
B and R stand for the blue and red component
signals, respectively, and Y indicates the
luminance signal. Refer to the DVD player's
instructions for use for definitions and
connection details;
- to get an optimal viewing, it is advised to switch
your equipment to the highest possible
supported display modes.
Warning: in case you notice scrolling images,
wrong colours or no colour, no picture, or even
combinations of these on your screen, verify if
the connections are done in the correct way and
if the resolution and the signal standard of the
connected equipment are set in the right way.
See the handbook for your equipment.
Note: This television is designed to accept high
definition signal standards 480p, 576p, 720p and
1080i as specified by the Electronic Industries
Association standard EIA770.3.
Digital devices from different manufacturers have
the possibility of differing output standards which
may cause difficulties for the television to
properly display.
EXT3
DIGITAL
. Also select Digital
EXT3
jacks and to the
R L/R
3.
EXT3
EN
45 45 45 45