Spartus Half mask 60 User Manual

Advertisement

Quick Links

SPARTUS® half mask 60 / 70G / 75G
IMPORTANT! Keep these user Instruction for reference.
Before using the half mask and the related filters, must carefully read and understand the instruction, and strictly abi-
de by the relevant content and retention of instruction in use process, please reference. The half masks meet the re-
quirement of Regulation (EU) 2016/425 and CE marked accordingly, and have been tested according to EN 140:1998.

Assembly instructions

A – half mask, B – filter
A1 Please assemble two filters
before wearing
A4 Release the inferior head
harness and place it on
neck, then pull the head
harness to proper position
to get a good seal.
B2 Turn the filter anticlockwise
for removing the gas filter.
A2 Loosen the head harness.
Hold the half mask in the po-
sition over nose and mouth.
A5 Press the palm of your hand
over the exhalation valve
cover and exhale gently. If
no air leaks are being noti-
ced between face and mask
a proper fit has been achie-
ved. If a leak has been detec-
ted reposition the respirator
and readjust the tension of
the head harness to eliminate
leakage. Repeat the fit check.
B3 Align the particle filter with
the mask connector base and
put them together. Turn the
filter clockwise to stop.
USER'S MANUAL
A3 Place the superior head har-
ness on the top of the skull. If
necessary, readjust the head
harness.
B1 Align the gas filter with the
mask connector base and put
them together. Turn the filter
clockwise to stop.
B4 Turn the filter anticlockwi-
se for removing the particle
filter.
EN

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Half mask 60 and is the answer not in the manual?

Questions and answers

Summary of Contents for Spartus Half mask 60

  • Page 1 SPARTUS® half mask 60 / 70G / 75G USER’S MANUAL IMPORTANT! Keep these user Instruction for reference. Before using the half mask and the related filters, must carefully read and understand the instruction, and strictly abi- de by the relevant content and retention of instruction in use process, please reference. The half masks meet the re- quirement of Regulation (EU) 2016/425 and CE marked accordingly, and have been tested according to EN 140:1998.
  • Page 2 7. If you cannot achieve a proper fit, do not enter the contaminated area. Inspection procedure SPARTUS® half mask must be inspected before use to ensure that it is in good operating condition. Half mask should be replaced of upon observation of damaged or defective parts. The following inspection procedure is suggested: 1.
  • Page 3 Reusable particulate filter Storage temperature range SPARTUS® FILTERS Before using the SPARTUS® filters, please carefully read and understand the instructions, and strictly follow it. Improper use may cause serious injury, harm to your health or death. Use instructions 1. Check the filter and package prior to use. Ensure the fillter is good condition. Do not use if there are hole, deformation, crack on the filter.
  • Page 4 If the particulate filter is dirty, damaged or the inhalation resistance increases signicantly, it must be replaced immediately. SPARTUS® particle filter meet the requirement of Regulation (EU) 2016/425 and CE marked accordingly, and have been tested according to EN 14387:2004+A1:2008.

This manual is also suitable for:

Half mask 70gHalf mask 75g

Table of Contents