1 OPERATION PRESENTATION The Regatta Compass sensor is a measuring instrument that provides the magnetic heading, heel and pitch of the boat. It is connected to the Regatta Compass interface of your TOPLINE installation. The sensor is equipped with a 10-meter cable, a mounting bracket, two screws and the Regatta Compass interface.
LIST OF CHANNELS DISPLAYED The Regatta compass, connected to the TOPLINE bus of your installation, creates the channel below. They are accessible from the displays of the TOPLINE range. Channel Display Unit MAGN HDG 245° Degree Magnetic heading HEEL Degree...
Please refer to the user guide of your display to adjust the filter setting. Technical specifications Power supply: 10 to 16VDC Power consumption: <200mA (Compass & Interface) Resolution: 0.1° (with Processor) Roll and pitch measurement range: +/- 50° Tightness: IP66 Weight: 270g Operating temperature: -10°C to +50°C Storage temperature: -20°C to +60°C...
OFFSET SETTING 2.1.1 Principle After the installation, it is necessary to adjust the OFFSET of the Regatta Compass so that the magnetic heading displayed is identical to the true magnetic heading. In order to do that, you must carry out an actual test at sea with your boat. Take the GPS unit of your boat as reference, and make sure there is no current and the sea is calm in the area chosen for this test.
Page 7
Please refer to the user guide of your display to perform the setting. 46_Regatta_Compass_Interface_um_EN_14...
COMPASS AUTOCOMPENSATION On some boats, the Regatta Compass may be strongly disrupted by its environment. Despite a careful installation and an offset properly adjusted, an important difference remains between the magnetic heading displayed and the true magnetic heading, throughout the measurement range between 0 and 359°.
The electrical windlass. High voltage electrical cables. Before installing the Regatta Compass, you can check that the location will not be disrupted by following the procedure below: Place a bearing compass at the selected location. Then, with your boat, execute a full 360°...
INSTALLING THE COMPASS ON A VERTICAL SURFACE Using a spirit or electronic level, mark the mounting holes of the mounting bracket at the chosen location. Drill the 4mm holes and screw the self-tapping stainless steel screws. Drill 6mm holes for the mounting bracket centre screws. Spirit level Mounting bracket Vertical oblong hole...
Page 11
Compass Serial Threaded pin number Connector Connector Seal Arrow pointing forward Using screws: The screws allow the space needed for the compass and its mounting bracket to be optimised. Installation of the compass Compass Seal Threaded pin Cable Mounting bracket Positioning screws Washers...
Page 12
Insert the seal onto the compass so as to match the mounting holes between the compass and the seal. Pass the cable through the mounting bracket and place the compass onto its mounting bracket. Line up the “Forward” arrow with the centreline of the boat. Screw the mounting screws or nuts, depending on the chosen solution.
Page 13
Compass Threaded Connector Serial number Connector Connector Seal Positioning arrow Mounting surface Flat washer Lock washer 46_Regatta_Compass_Interface_um_EN_14...
CONNECTION TO THE TOPLINE BUS Run the compass bus cable to the interface of the Regatta Compass of your installation. Connect the bus cable of the Regatta compass interface to a terminal box. Connect the bus cable inside the terminal box: If you reduce the length of the bus cable, strip and galvanise the wires before connecting them inside the terminal box.