Advertisement
Quick Links
Advertisement
Related Manuals for Saveo Scan SAVEO-EMB-S12D
Summary of Contents for Saveo Scan SAVEO-EMB-S12D
- Page 1 SAVEO-EMB-S12D Quick Setup Guide...
-
Page 2: Command Barcodes
Command Barcodes Scanning the Enter Setup Code can enable the engine to enter the setup mode. Then you can scan a number of command codes to configure your scanner. To exit the setup mode, scan the Exit Setup code. Setup Exit Setup Enter Important Notes:... - Page 3 Scanning Mode Trigger Mode (Default) Scanning this bar code will enable the scanner to enter manual trigger mode. **Trigger Mode Auto Sense Mode Scanning this bar code will enable the scanner to enter auto sense mode. Automatic Scanning Mode Continuous Mode This mode enables the engine to scan/capture, decode and transmit over and over again.
- Page 4 USB Interface (Optional) USB HID-KBW By default, the scanner is in HID mode as a Keyboard device. It works on a Plug and Play basis and no driver is required. **USB HID Keybord USB COM Port Emulation If you connect the scanner to the Host via a USB connection, the USB COM Port Emulation feature allows the host to receive data in the way as a serial port does.
- Page 5 Serial Baud rate 9600(default) 19200 38400 57600 115200 230400 Enter Configuration Exit Configuration...
- Page 6 Terminator Configuration The scanner provides a shortcut for configuring the terminating character suffix to CR or CRLF and enabl it by scanning the appropriate barcode below. No terminator CR/LF **CR/Enter Caps Lock Disable Enable Enter Configuration Exit Configuration...
- Page 7 Same barcode reading Do not re-read the same barcode Interval reading Arming Light Enable when scanning Enable Always Disable Enter Configuration Exit Configuration...