Installation; Unpacking - AEG LAVAMAT 85 Instruction Booklet

Installation

Unpacking

All transit bolts and packing must be
removed before using the appliance.
Using a spanner, unscrew and remove the
rear right-hand bolt and lay the machine on
its back, taking care not to squash the hoses.
This can be avoided by placing one of the
corner packing pieces between the machine
and the floor.
Remove the
polystyrene
block from the
bottom of the
machine and
release the two
plastic bags by
removing the
adhesive strip.
Carefully remove
the right-hand bag (1) then the left-hand bag (2) by pulling them towards
the centre of the machine.
Set the machine
upright and
remove the two
remaining bolts
from the back.
Pull out the
three plastic
spacers from the
holes into which
the bolts were fitted.
Plug the open holes with the plugs which you will find at the back of the
appliance.
You are advised to keep all transit devices so that they can be refitted
if the machine ever has to be transported again.
70
2
1