A
fter your personal access code has been set
(see previous page), you are now ready to
select the channels you want to block out or censor.
Once you've entered your access code and the
AutoLock™ features are displayed on the screen:
1
After Setting your personal access code (see
previous page), press the CURSOR UP ˚
DOWN ¸
¸ buttons until the words Block
Channel are highlighted.
2
For digital mode:
Press the CURSOR RIGHT ˙
the Channel Blocking menu. Press OK to lock or
unlock the channel.
For analogue mode:
Press the CURSOR RIGHT ˙
blocking ON or OFF for that channel. When ON
is selected the channel will be blocked.
3
For analogue mode:
Press the CURSOR UP ˚
ton to select other channels you wish to block.
For analogue mode:
Press the CH + or CH – button to select other
channels you wish to block.
Repeat steps 2-3 to block the new channel.
4
When finished, press the MENU button three
times to remove the menu from the screen.
H
ELPFUL
Use the A/D button on the Remote Control to
switch between Digital and Analog channels.
NOTE: If you ever forget your code, the 0, 7, 1, 1 code
is the factory default and can be used to enter and create
a new access code. Enter the above number twice.
B
LOCK
˚ or
˙ button to enter
˙ button to turn
˚ or DOWN ¸
¸ but-
H
INTS
C
P
HANNELS
ART
23
2