Ground Zero URANIUM Series Owner's Manual page 13

1 Line Input (RCA
2 Sensitivity Control
HPF activation switch
HPF multiplication switch
3
HPF filter controller
LPF activation switch
LPF multiplication switch
4
LPF filter control
* BPF feature
5 Loudspeaker Terminal
6 Status LED
7 Fuse(s)
Power
8
Terminal
9 Phase Switch/Control
10 Bass Boost Control
11 Bass Remote Socket
GROUND ZERO GZUA SQ AMPLIFIER
Common Controls & Features
Input sockets to connect RCA wires
Controller to adjust the input sensitivity of the according channels
Push the switch to the ON position to activate the high pass filter
Push the switch to the x10 position to multiply the frequency by the
factor of 10. The crossover frequency range will be swapped from
20~400 Hz to 200~4000 Hz
Adjust the required crossover point using the controller.
Frequencies below the selected crossover point will be filtered
Push the switch to the ON position to activate the low pass filter
Push the switch to the x10 position to multiply the frequency by the
factor of 10. The crossover frequency range will be swapped from
20~400 Hz to 200~4000 Hz
Adjust the required crossover point using the controller.
Frequencies above the selected crossover point will be filtered
Activating the high and the low pass filter results in a band pass
filter. Depending on the multiplication switches the band pass filter
range varies from 20~4000 Hz
To connect the loudspeaker wires in stereo or in bridged mode
POWER
PROTECT
Replace a defective fuse only by a new fuse with identical value
BATT +
To connect to a positive power wire from the battery terminal
REMOTE
To connect the remote switch output wire of the head unit
GND
To connect to a ground wire from the battery or to chassis ground
Additional Features of GZUA 2SQ
To activate phase adjustment (0°~180˚)
To adjust the bass boost level ( from 0~12 dB @ 45 Hz)
To connect the wired bass level remote control
-> white -> ok (correct operation)
-> red -> error / protection
URANIUM SERIES