Advertisement
If you have a J abra Pro 920 or Pro
925
follow these instructions.
Put on the headset, and simultaneously press and hold both volume buttons (+) and (-) on the top of the headset
until the Voice prompt says "Set up" then release the buttons.
Press the black multifunction button on the side of the headset and cycle through the settings until you hear
"Remote Call Control"
Then press the (+) button until you hear "Jabra IQ"Then press and hold both volume buttons again until the voice
prompt says "Goodbye"
The base will restart and apply the new settings
If you have a J abra Pro
9450
follow these instructions.
1. Ensure there are no active calls.
2. Remove the front panel of the Jabra PRO 9450 base.
3. Center-press (push it directly in rather than side to side) the microphone volume switch on the base
to enter setup mode. The mute indicator will blink slowly to indicate setup mode.
4. Tap the desk phone button on the keypad to cycle through the settings. The first setting is Remote call
control (the phone symbol on the base should be solid white to indicate remote call control mode)
5. Tap the softphone (computer) button on the keypad to cycle through the values for each setting. For
GN1000 mode the computer light on the headset base needs to be a S OLID yellow.
6. When finished, center-press the microphone volume switch to save settings and exit setup mode. The
base will restart.
If you are using a Jabra pro 9 460/9470/Motion
office
; follow these instructions:
With the headset sitting on the base please press the spanner in the top right corner.
use the arrow to scroll down to phone settings then click that.
click on desk phone
click on setup desk phone
It will bring up a message saying you will be unable to make calls. Press confirm.
It will then ask if you would like guided or manual setup - click Manual please.
Select Adapter – Jabra IQ
Set clear dial tone switch - Select A by pressing the + button. Then press the right arrow at the
bottom
Set microphone level - 7 is usually fine (can always come back and change this later if required).
Then press the right arrow down the bottom
It will then say setup complete - press the right arrow at the bottom
It will then say the base will restart - click the X in the bottom right.
The base should restart and you should now be able to answer/end from the headset.
Advertisement
