The lights can self-float on the water because of the unique structure design. LNK-LSL-3A : Only with signal flashing light , can be manually turned off and on while the water sensors contact with water.
Page 4
Operation and Maintenance Instruction LNK-OM-LSL-3A&W / V2.2 LNK-LSL-3A LNK-LSL-3AW Figure 2-2 Manual switch label Technical Parameter Technical parameter Specification Battery Lithium battery Light source LONAKO patented LED Chromaticity White Light type Flashing LNK-LSL-3A Light type Flashing-Steady-SOS-OFF LNK-LSL-3AW Flash Frequency 50~70times/min Luminous Intensity ≥0.75cd...
Page 5
II 2 G Ex ia IIC T3 Gb -35℃≤Ta≤65℃ Ex Marking (Zone 1,2) Table 2-1 Technical parameter 2.4Marking 2.4.1 Standard product markings of LNK-LSL-3A & LNK-LSL-3AW lifejacket lights are shown as below Figure2-3 (MED marking) and Figure 2-4 (ATEX marking): ① ④ ②...
NSTALLATION NSTRUCTIONS 3.1 Installation Limitation LNK-LSL-3A and LNK-LSL-3AW lifejacket lights are fit for all types of lifejackets. The products shall not be installed in electrostatic charge conductive location. 3.2 Installation Requirement LNK-LSL-3A and LNK-LSL-3AW lifejacket lights are supplied with fix buckles. The buckle is normally placed behind a belt of lifejacket or fixed through the fiber at suitable position near the shoulder of lifejacket.
& S ERVICE AFETY 5.1 The life of LNK-LSL-3A and LNK-LSL-3AW lifejacket lights are five years from the date of manufacture. During the service time the storage and application conditions meet the Section Ⅳstorage requirements. 5.2 Once the light was been activated ,it can keep working for more than 10hrs at over 0.75 cd light intensity.
SECTION Ⅶ M AINTENANCE LNK-LSL-3A and LNK-LSL-3AW lifejacket lights are maintenance free, but in the storage period, do not contact water sensors with hands and ensure the water sensors keep dry all the time. And ensure it not conduct with electrostatic charge hazardous.