Table of Contents
Advertisement
Quick Links
Ultra-wideband Location System
UBISENSOR30V1 (Revision D)
User's Manual
Written By
Andy Ward
Ubisense Limited
St Andrews House, St Andrews Road, Cambridge CB4 1DL,
ENGLAND
Tel:
+44 (0)1223 535170
Fax:
+44 (0)1223 448167
Email:
support@ubisense.net
WWW:
http://www.ubisense.net/
Revised: November 2022
Copyright © 2022 Ubisense Limited, All Rights Reserved
Advertisement
Table of Contents
Related Manuals for Ubisense UBISENSOR30V1
Summary of Contents for Ubisense UBISENSOR30V1
- Page 1 User’s Manual Written By Andy Ward Ubisense Limited St Andrews House, St Andrews Road, Cambridge CB4 1DL, ENGLAND Tel: +44 (0)1223 535170 Fax: +44 (0)1223 448167 Email: support@ubisense.net WWW: http://www.ubisense.net/ Revised: November 2022 Copyright © 2022 Ubisense Limited, All Rights Reserved...
-
Page 2: Table Of Contents
Mounting options ........................ 5 Powering the Ubisensors ....................5 Setting up sensors ......................5 Switching on the Ubisensor ....................5 Calibrating the Ubisensor ....................6 Troubleshooting ........................6 Ubisensor Specifications ......................7 Copyright © 2022 Ubisense Limited, All Rights Reserved... -
Page 3: Introduction
Introduction The UBISENSOR30V1 is a basestation used by the Ubisense Location System, which supports the real-time location of objects. It detects ultra-wideband (UWB) pulses emitted by wireless tags (Ubitags), allowing the 3D position of the tags to be found. The use of UWB technology enables greater positioning accuracy than other wireless technologies, because it is much less susceptible to multipath interference effects. -
Page 4: Regulatory Information For Canada
Innovation, Science and Economic Development Canada documents RSS- GEN, RSS-102 and RSS-210. Cet appareil (PMN : UBISENSOR30V1 ; HVIN : UBISENSOR30V1; IC : 8673A-SENSOR33) est approuvé en vertu des documents d'Innovation, Sciences et Développement économique Canada RSS-GEN, RSS-102 and RSS-210. - Page 5 Regulatory Information for Europe Hereby, Ubisense Limited declares that the radio equipment type UB-Tag Dimension4 UWB+BLE tag (D4UWBBLE) is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: www.ubisense.net...
-
Page 6: Features Of The Ubisensor
Features of the UBISENSOR30V1 The diagrams below show several important features of the UBISENSOR30V1: Figure 1 – UBISENSOR30V1 Front Figure 2 – UBISENSOR30V1 Rear Ubisense – Ultra-wideband Location System – UBISENSOR30V1 Revision D... -
Page 7: Installation And Operation Instructions
Switching on the UBISENSOR30V1 To turn on the UBISENSOR30V1, simply turn on the power to the device. The status LED on the front of the unit should illuminate, and the device will begin to attempt to contact the Ubisense location system dataset (which should already have been installed on your network –... -
Page 8: Calibrating The Ubisensor
Calibrating the UBISENSOR30V1 When the UBISENSOR30V1 has been installed in its final location, its position and orientation must be found and entered into the Ubisense location system’s dataset. The Ubisense location system management tools make this calibration process simple and quick – refer to www.ubisensedimension4.com... -
Page 9: Ubisensor Specifications
2401.750MHz (802.15.4f-2012 channel 15) Highest channel frequency: 2481.750MHz (802.15.4f-2012 channel 56) Maximum average output e.i.r.p.: -4.3dBm General specifications Dimensions: 200mm x 140mm x 60mm Power supply: 48V PoE Operating temperature range: -40ºC to +60ºC Ubisense – Ultra-wideband Location System – UBISENSOR30V1 Revision D...
Need help?
Do you have a question about the UBISENSOR30V1 and is the answer not in the manual?
Questions and answers