Related Manuals for Ubisense Ubitag V2.2
Summary of Contents for Ubisense Ubitag V2.2
- Page 1 " " %& '( )* + .&& / 0' 1 212' 3 4- .&& / 0' 1 212'5 - 8 8 # # # 7...
-
Page 2: Table Of Contents
Table of Contents Introduction ............................1 Information to the User ........................1 Features of the Ubitag ........................2 Installation and Operation Instructions .................... 3 Switching the Ubitag on for the first time.................. 3 Fitting or replacing the batteries in the Ubitag................3 Troubleshooting........................ -
Page 3: Introduction
Introduction The Ubitag V2.2 is a wireless device intended to be used for the real-time location of objects within buildings. It transmits ultra-wideband pulses which are picked up by a network of basestations (Ubisensors) placed inside the building, allowing the 3D position of the tag to be found. -
Page 4: Features Of The Ubitag
Features of the Ubitag The diagram below shows several important features of the Ubitag: Programmable LED (visible though enclosure) antenna Strapping slots Programmable button Mounting holes Ubisense – Ultra-Wideband Location System – Ubitag V2.2... -
Page 5: Installation And Operation Instructions
When the battery has been replaced, the Ubitag will flash its LED to indicate correct start-up, and the Ubisense Location System will then be able to determine the Ubitags’ location. Replace the PCB back into the front of the enclosure, replace the rear enclosure half and then tighten the four screws removed previously to complete reassembly of the device. -
Page 6: Troubleshooting
Ubisensor network, and that tracking functionality is not available at that location. Ensure that the tag is within an area covered by the Ubisense Location System. If you are still unsure as to whether or not the Ubitag is operating correctly, contact your system administrator, who should be able to use Ubisense’s monitoring tools to determine the extent and... -
Page 7: Ubitag Specifications
(4) Field disturbance sensors installed inside of metal or underground storage tanks are considered to operate indoors provided the emissions are directed towards the ground. (5) A communications system shall transmit only when the intentional radiator is sending information to an associated receiver. Ubisense – Ultra-Wideband Location System – Ubitag V2.2...
Need help?
Do you have a question about the Ubitag V2.2 and is the answer not in the manual?
Questions and answers