G4S S874-EX Installation And User Instructions

Installation and User Instructions for S874-EX Keypad Readers
The S874 is a contactless smart-card reader, with LED's and keypad. The
reader can be set to use Wiegand or
The S874 reader will read smartMAX encoded MIFARE cards and card
serial numbers from most ISO 14443A smart cards which have a 4-byte
UID (User Identification). The reader may be configured to read other card
types by presenting a programming card to the reader during start up.
For additional information regarding the installation, configuration and
proper use of this product:
SMS User Guide, P/N 9600-0429, M2150 Access Control Design Guide,
P/N 9600-0420,
Fit The Weather Proofing Kit
1
When mounting outside, the gasket kit must be fitted:
a) Remove the backplate from the reader after screwing
the securing screw 'C' fully IN.
b) Position the gasket between the back plate and the
mounting surface.
Note: For UL listed applications, use only
manufacturer provided gasket, P/N 87X-GASKET.
Mount the Backplate
2
Mount the backplate using countersunk headed screws
adjacent to the opening edge of the door.
If fixing hole 'A' is used then the breakout must be removed
and the screw must not protrude.
Feed the cable from the controller through the backplate.
If the wall tamper function is to be used then the small hole in
breakout 'B' may be used to mark the position of the wall
screw before the breakout is removed. An appropriate wall
screw should then be adjusted in height to protrude through
the hole to activate the tamper lever.
The front cover is secured to the backplate by
UNSCREWING the securing screw 'C' via the small hole
in the enclosure so that the screw head locates in the
counterbored hole on the inside of the enclosure.
The screw should not be removed from the backplate.
20mA current loop communications.
B A
C
You should find
that the backplate
has holes for
connection to most
standard electrical
backboxes.