Table of Contents
Advertisement
WWW.INDEXELEKTRO.NL
Over tightening of cable glands, blanking plug and relevant sealing bolts might impair the protection category.
Commisioning
- Please ensure the following conditions before the light fitting is prepared for running:
* The light fitting has been installed properly.
* Unused cable entries must be sealed.
* The light fitting has not been damaged.
* The LED signaling gives the following signals:
- Green - Main electric induction
- Yellow - Fault indication
- Red
- Charge indication
Maintenance / service
- Observe the national regulation of control overhaul and standard seriously. The components that have important influence to
the explosion-proof performance shall be examined carefully. Before disassembling or replacement make sure that the device
is disconnected from the voltage. Repairs and overhaul may only be carried out with original INDEX ELEKTRO spare parts
and by a qualified electrician!
- Modifications to the device or changes of its design are not permitted.
- If there are damaged explosion-proof parts, only original parts supplied by Index Elektro BV may replace them. If you have any
question about fault, consult or return the product to Index Elektro BV for repair.
- The repair and maintenance should be performed by the professional and qualified person;
- Please note: cleaning of the light fittings is only allowed with a damp cloth
- The following points must be checked during maintenance;
* Check if the built-in component is damaged;
* Check if the built-in component is fixed reliably;
- Over tightening of cable glands, blanking plug and relevant sealing bolts might impair the protection category.
- All sealing devices act as the seal. When ageing phenomenon's such as crack, softening etc appear, the seals should be
changed with original seals from Index Elektro BV.
- The following points are recommended to check when it appears that the lamp tube cannot be lighted during maintenance:
o Whether the power supply system is normal or not.
o Whether the fuse module is switched off or not.
- LED signal indicator status: Green-Main electric induction, Yellow-Fault indication, Red-Charge indication
- Whether the battery can discharge normally and whether it is aging or not.
- Whether the electrical components such as control switches, drivers etc. are fault or not.
- The batteries are consumable elements, please change for a new one timely.
Warning: Do not discharge or replace battery in an explosive atmosphere
Accesories / spare parts
- Only the original accessories and spare parts which are made by Index Elektro BV can be used.
For some accessories and supplies see our latest catalogue or visit the website
Disposal / recycling
- The respective valid national regulations for waste disposal shall be observed when disposing of the apparatus!
- We are pleased to answer any special questions you may have. Please contact Index Elektro BV.
www.indexelektro.nl
-8-
Z0865/0866-rev.17.08.17
Advertisement
Table of Contents
