Related Manuals for MEGATRONIX KE 680
Summary of Contents for MEGATRONIX KE 680
- Page 1 KE 680 DELUXE 4-CHANNEL KEYLESS ENTRY SYSTEM Installation And Operation Manual MEGATRONIX CALIFORNIA, U.S.A. KE 680...
-
Page 2: Installation Diagram
7. Light Green / Black Wire: (-) 200mA 2-Step Door Unlock Output. 8. Purple / Black Wire: (-) 200mA Timer Controlled Channel 4 Output 9. Red / White Wire: (-) 200mA Channel 3 (Trunk) Output 10. Black / White Wire: (-) 200mA of Dome Light Output KE 680... - Page 3 RED wire (pin #30) of relay and connect starter wire to WHITE wire (pin #87a) of relay. e). Connect ORANGE wire from control module to ORANGE wire (pin #86) of relay. f). Connect ORANGE wire (pin #85) of relay to switched 12 volts source from the ignition switch. KE 680...
- Page 4 Green / white Green / white M aster Locking Locking Blue / white Blue / white Switch Switch Door Lock Door unlock Door Lock Door unlock Green / yellow Green / yellow + 12V Blue / yellow Blue / yellow KE 680...
- Page 5 Blue / Yellow + 12V Lock Relay OEM Door Lock Relay Driver's Door Lock OEM Driver's Motor Door Lock To All Other Motor Door Lock To All Other Cut Existing Unlock Cut Existing Unlock Door Lock Motor Wire Motors Wire KE 680...
- Page 6 5 or 7 seconds and window will close directly. If your vehicle with “COMFORT feature” and you wish the door being locked and the window being closed “with comfort feature”. II-1 automatically at the same time by remote control, you can set the alarm feature KE 680...
- Page 7 “TEST” Mode for Zone 2 Hood & Zone 3 “TEST” Mode for Zone 4 / the Optional Door Pin Switch Sensor connected to 4-pin plug. Exit: Turn Ignition to the 'ON' position, or leave it for 15 seconds. 3 long chirps will confirm exit. KE 680...
- Page 8 5 seconds, there will be a confirmation six chirp with 3 long chirp to confirm the system Alarm Feature I & II & III & IV Programming all returns to factory default setting. KE 680...
-
Page 9: Operation
On this mode, for the zone 4 shock sensor, the trigger timer will reduced from 30 seconds to 15 seconds. The noiseless feature is programmed to activate for one arming cycle only. The security system will return to normal operation during the next arming cycle. KE 680... -
Page 10: Passive Arming
To use the valet mode, the system must first be disarmed either by using your remote transmitter, or by operating the Manual override sequence. Enter Valet Mode: 1. From the disarmed condition, turn the ignition to the “ON” position. KE 680... - Page 11 This unit is capable of 2-way communication to notify the owner if anyone is trying to tamper with the vehicle or to confirm remote start operation. If you would like to upgrade this unit to a 2-way system by purchasing a 2-way LCD transceiver, please contact your authorized reseller. KE 680...
- Page 12 This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions. (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. KE 680...
Need help?
Do you have a question about the KE 680 and is the answer not in the manual?
Questions and answers