Advertisement
WARNING!
Before replacing the lamp, be sure
to disconnect the power cord plug
from the wall outlet.
CAUTION!
Do not use the old lamp unit.
Accessories
Air filter : 2 pcs.
Precautions on lamp unit replacement
Remove the power plug and confirm that the surroundings of the lamp unit have cooled off.
Be careful when handling a light source lamp. The lamp unit has high internal pressure. If improperly handled,
explosion might result.
A used lamp unit may burst if it is handled violently.
For disposition of used lamps, request an industrial waste disposal contractor.
If you continue to use a lamp after the replacement time, the lamp may break.
Philips screwdriver is necessary when replacing a lamp unit.
Take care not to slip your hand when using a screwdriver.
Note
• It is not possible to turn on the power unless two lamp units are installed.
Timing of lamp unit replacement
The lamp units are consumable parts. The lamp brightness decreases gradually as the cumulative operating time
increases, so periodic replacement is necessary. The replacement guideline is 3 000 hours, although the lamp may
become dead (will not light) before 3 000 hours is reached depending on the characteristics of individual lamps and
other factors such as the operating conditions and the installation environment. Therefore, it is recommended for
the user to keep a spare lamp unit.
The risk of the lamp bursting increases after 3 000 hours of operation, so the lamp unit turns off automatically.
After
2 800 hours
After
3 000 hours
2
On-screen indication
REPLACE THE LAMP
The indication appears for 30
seconds or until any control button
is pressed.
The indication will not disappear
unless a control button is pressed.
WARNING!
Do not disassemble the lamp unit.
Lamp monitor
LAMP
The lamp monitor lights up red
even in standby mode.
Advertisement
