Table of Contents
Advertisement
Tip: If the ice cubes taste stale, dispose of the remaining
ice cubes and the cubes produced over the next 24 hours.
If the ice cubes still taste stale, change the water filter.
Putting the ice maker into operation
Notes
¡ Ice cube production starts as soon as the appliance is
switched on and the freezer compartment has reached
the set temperature.
¡ As soon as the freezer compartment reaches the set
temperature, the first batch of ice cubes will be ready in
approximately 4 hours.
Requirement: The appliance is connected to the drinking
water connection.
For hygiene reasons, discard the ice cubes produced
▶
within the first 24 hours.
Switching on ice cube production
Press the ice cube maker button.
▶
a The ice maker button lights up.
Note: If you press and hold the ice maker button for 3 sec-
onds, the filter change status is reset.
Switching off ice cube production
Press the ice cube maker button.
▶
a The ice maker button goes out.
Note: If you press and hold the ice maker button for 3 sec-
onds, the filter change status is reset.
14 Defrosting
Defrosting
Defrosting
14.1 Defrosting in the freezer compartment
The fully automatic NoFrost system ensures that the
freezer compartment remains frost-free. Defrosting is not
required.
15 Cleaning and maintenance
Cleaning and maintenance
To keep your appliance working efficiently for a long time,
Cleaning and maintenance
it is important to clean and maintain it carefully.
Customer Service must clean inaccessible points. Clean-
ing by Customer Service can give rise to costs.
15.1 Preparing the appliance for cleaning
Switch off the appliance. → Page 10
1.
Disconnect the appliance from the power supply.
2.
Unplug the appliance from the power source or switch
off the circuit breaker in the fuse box.
Take out all of the food and store it in a cool place.
3.
Place ice packs (if available) onto the food.
Remove all fittings and accessories from the appliance.
4.
→ Page 16
Remove the door rack rail. → Page 17
5.
15.2 Cleaning the appliance
WARNING
Moisture intrusion may cause an electric shock.
Do not use any steam cleaners or high-pressure clean-
▶
ers to clean the appliance.
NOTICE:
Unsuitable cleaning agents may damage the surfaces of
the appliance.
Do not use hard scouring pads or cleaning sponges.
▶
Do not use strong or abrasive cleaning agents.
▶
Do not use cleaning agents with a high alcohol content.
▶
Do not use stainless-steel cleaning agents on the out-
▶
side of the appliance.
If you clean fittings and accessories in the dishwasher, this
may cause them to become deformed or discolor.
Never clean fittings and accessories in the dishwasher.
▶
Prepare the appliance for cleaning. → Page 15
1.
Clean the following with a dish cloth, lukewarm water
and a little pH-neutral liquid detergent:
– The outside of the appliance
– The inside of the appliance
– The fittings
– The accessories
– The door seals
Dry thoroughly with a soft, dry cloth.
3.
Insert the fittings and install the appliance components.
4.
Connect the appliance to the electricity supply.
5.
→ Page 7
Put the food into the appliance.
6.
Defrosting en-us
15
Advertisement
Table of Contents
