Skov DA 73 Technical User Manual

Skov DA 73 Technical User Manual

Winch motor

Advertisement

Quick Links

DA 73 Winch Motor
Technical User Guide
2022.07.21 • 604243

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DA 73 and is the answer not in the manual?

Questions and answers

Summary of Contents for Skov DA 73

  • Page 1 DA 73 Winch Motor Technical User Guide 2022.07.21 • 604243...
  • Page 3 Should any mistakes or imprecise information occur in spite of this, SKOV A/S would appreciate being notified thereof. • Irrespective of the above, SKOV A/S shall not accept any liability with regard to loss or damage caused or alleged to be caused by reliance on any information contained herein.
  • Page 4 Check Direction ....................... 6 Limit Range Adjusting ..................... 7 Installation Diagram....................8 Positioning the Control Box ................... 8 INSTALLATION GUIDE ..................9 Cable Plan ........................ 9 Circuit Diagram .......................10 CLEANING ...................... 10 TECHNICAL DATA ..................11 Dimensioned sketch ....................11 DA 73 Winch Motor...
  • Page 5: Product Description

    Technical User Guide 1 Product Description DA 73 220 V is a drive motor designed to control the opening and closing of the Tunnel Door. e.g. in livestock house ventilation systems. DA 73 220 V permit independent adjustment of pulling length and pulling direction. DA 73 consist of a gear motor and controller box.
  • Page 6: Mounting Guide

    If not, then switch around the red and blue wires (switch OFF 220 V power when moving wires) • Check again if opens the house ? • Put the AUT/MAN-switch at AUT (at the DA 73 Motor controller box) • Set the housecomputer in MANUAL in the servicemenu • Set the housecomputer to 100% opening •...
  • Page 7 If it is not correct, please review the manual carefully and redo the above step-5 again. After the limit adjust is finished. Make sure to fasten the lock bolts. Or the limit will not be accurate DA 73 Winch Motor...
  • Page 8: Installation Diagram

    Correct installation Incorrect installation 2.5 Positioning the Control Box Place the control box in appropriate height for operation and the installed cable. Mount the cables in the box according to the circuit diagram. DA 73 Winch Motor...
  • Page 9: Cable Plan

    EU standards that are applicable in Europe. The installation of a power supply isolator is required for each motor and power supply to facilitate voltage-free work on the electrical equipment. SKOV A/S does not supply the power supply isolator. 3.1 Cable Plan...
  • Page 10: Circuit Diagram

    Technical User Guide 3.2 Circuit Diagram 4 Cleaning Clean the product with water and a brush without using: • high-pressure cleaner • solvents • corrosive/caustic agents DA 73 Winch Motor...
  • Page 11: Technical Data

    Technical User Guide 5 Technical Data Winch motor DA 73 220V Electrical Operating voltage [ V AC] 220 ± 20% Power consumption [A] Mechanical Max Torque [Nm] 100 Nm Max.continuous running time 22 min. Position Time Based Enviroment Ambient temperature [°C] -20 to 50 Storage temperature [°C]...
  • Page 12 SKOV A/S • Hedelund 4 • Glyngøre • DK-7870 Roslev Tel. +45 72 17 55 55 • Fax +45 72 17 59 59 • www.skov.com • E-mail: skov@skov.dk...

Table of Contents