Advertisement
INSTALLATION INSTRUCTIONS
Johnson Suisse Emilia FTW Suite
Code JTTE401.JTTE402
6. For P Trap installations a pan connector and extension will be required.
7. Fit the threaded cistern fixing inserts into the holes in the cistern platform of the pan (
8. Move the pan back into position ensuring it is properly engaged with the pan connector.
9. Fit the screws into the floor fixing brackets and affix decorative caps. A waterproof sealant may be applied around
the pan base.
Note - if mortar bedding is required use a 4:1 sand and standard cement mix (do not use Rapid Hardening
Cement). If the floor is tiled, cut out the tiles beneath the pan to create a good bonding surface.
10. Cistern fitting - The water supply to the inlet valve must be connected in accordance with AS/NZ3500.1.
a. Fit the blanking plug provided to seal the bottom inlet hole in the base of the cistern.
Note: for bottom water entry option a bottom water entry valve is required (not supplied). Refer to
b. Check that the inlet and outlet valve securing nuts are firmly tightened to prevent leaks. Do not over-tighten.
c. Fit the foam sealing ring to the outlet valve base
d. Fit the cistern to the pan using the seals, washers and bolts provided
evenly to compress the foam sealing ring.
e. Flush out the supply pipes before connecting the water supply.
installations. Note that any flexible hoses used must not be submerged in water.
DIAGRAM 4
OPTIONAL INLET VALVE KIT (XJ1O8) REQUIRED
FOR BOTTOM WATER ENTRY INSTALLATIONS
FLUSH WATER VOLUME MUST BE ADJUSTED
TO THE LEVEL MARK ON THE CISTERN
11.Fill the cistern and check the water level, if necessary adjust the inlet valve float so the water is at the indicated level.
12. Attach the cistern lid and buttons and test flush several times while checking for leaks
13. Fit seat (refer to specific instructions included with seat)
WARRANTY - Please visit www.johnsonsuisse.com.au for warranty terms and conditions
All installations should be carried out by a licensed plumber in compliance with the requirements of AS/NZS 3500.1 & AS/NZS 3500.2 and
any State or Local Authority Regulations.
Bathroom Products Australia Pty Ltd
2/97 Banksia St
Botany NSW 2019
THE EMILIA SUITE IS SUPPLIED WITH
AN ADJUSTABLE CONNECTOR FOR S
TRAP INSTALLATION (Diagram 6)
DIAGRAM 6
P TRAP HEIGHT 190mm
2/4
DIAGRAM 5
. Screw down firmly and
(DIAGRAM 5)
This is particularly important in new
DIAGRAM 5
CISTERN FIXING BOLTS
ASSEMBLY
SS WASHER
RUBBER WASHER
CISTERN BASE
WC PAN
PLASTIC WASHER
THREADED INSERT
)
DIAGRAM 4.
O-RING
BOLT
HEX NUT
Tel: 1300 717 717
Fax: 1300 746 480
www.johnsonsuisse.com.au
Advertisement
